one LIGHT 7844E COB LED Strip Light
SYMBOLS
DIMENSION
- A. CUT:
The LED strip can be cut every 5cm at the clearly marked positions. Cut carefully at the desired length by using a sharp pair of scissors. - B. INSTALLATION:
Remove the 3M double-face adhesive tape from the LED strip gradually during installation and fix into the required position. - C. CONNECT:
Connect the LED strip to the LED driver’s output. Please check the polarities when you connect it (red “+”, black ” -“).
INSTALLATION
Warnings
- The mounting surface must be clean, dry and free from dust or grease.
- Make sure that the product is installed properly before connecting to electricity.
- Do not bend, fold or twist the LED strip.
- Do not bend to install in corners.
- Do not put excessive pressure on the surface of LED strip.
- Do not cover LED strip with any materials.
- Do not install in ambient temperatures below -10°C or exceeding 45°C.
- Always handle the LED strip with care.
- The LED strip should not be exposed to direct sunlight.
- LED strips with different batch numbers may have slight variations in colour consistency (CCT ± 150K).
- Maintenance and installation should only be carried out by a professional electrician.
Tools Needed:
- Requires 24V DC driver.
- Supplied in 5m roll with double face adhesive tape.
MORE INFORMATION
Documents / Resources
 |
one LIGHT 7844E COB LED Strip Light [pdf] Instruction Manual 7844E COB LED Strip Light, 7844E, COB LED Strip Light, LED Strip Light, Strip Light |
