NSCD NCSD-318PV2 Radio Control Operator Transmitter
Using Instruction
INSTRUCTIONS FOR RADIO CONTROL OPERATOR TRANSMITTER
MODEL NO.: NCSD-318PV2
Read the following instructions thoroughly before using the transmitter. This transmitter must be adjusted so that the coding switches match the coding switches on your present operating transmitter or receiver.
Remove the transmitter cover
Remove the access cover from the front of the transmitter by sliding the cover away from the top of the transmitter(Figure A). This will expose the battery and the dip switches. The code can be changed using a small screwdriver.
Setting the code
You may set your transmitter to any code you desire, but be sure the code you set matches on both your transmitter and receiver. There are 8-bit dip switches on your transmitter, each of which can be placed in three different posit -ions(+,0,-). Do not set all switches in the same position, such as all + , all – , all O(Figure B).
WARNING: No other adjustments should be made inside the transmitter. Now that you have selected your personal code, replace the transmitter cover. The user can click the button. A signal is transmitted out. If the inside dip switch match the receiver switch, the receiver will work.
FCC NOTE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1 )this device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE MODIFICATIONS CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
- By Email: sales@northshorecommercialdoor.com
Figures
- Figure A: Diagram showing the removal of the transmitter cover.
- Figure B: Diagram showing the dip switch positions labeled 1 to 9 with positions +, 0, and -.
Contact Information
By Email: sales@northshorecommercialdoor.com
- North Shore Residential Door
- 162 Edgewood Street
- Elyria, Ohio 44035
- Phone: 800-783-6112
- Fax: 440-365-3514
Specifications
| Model Number | NCSD-318PV2 |
|---|---|
| Dip Switch Positions | +, 0, – |
| FCC Compliance | Part 15 |
FAQs
How do I remove the transmitter cover?
Slide the cover away from the top of the transmitter as shown in Figure A.
What should I do if the transmitter does not work?
Ensure that the dip switch settings on the transmitter match those on the receiver.
Can I set all dip switches to the same position?
No, do not set all switches in the same position, such as all +, all -, or all 0.
What happens if I modify the transmitter?
Unauthorized modifications could void your authority to operate the equipment and may cause interference.
Documents / Resources
 |
NSCD NCSD-318PV2 Radio Control Operator Transmitter [pdf] User Manual 318PV2, NCSD-318PV2 Radio Control Operator Transmitter, NCSD-318PV2, Radio Control Operator Transmitter, Operator Transmitter, Transmitter |