NOTIFIER Swift Smart Wireless Integrated Fire Detectors User Guide

 

 

REQUIRED TOOLS AND EQUIPMENT TO PERFORM RF SCAN TEST

 

BEFORE PERFORMING A RF SCAN TEST

Make sure devices are in Factory Default
With the code wheels set to 000, insert one battery into the device. The LED on the front will blink red if the device is in factory default.
If the device is not in factory default, follow the process on the next page.

If the devices are new out of the box, they will be in factory default. Proceed to page 5.

 

RESET DEVICES TO FACTORY DEFAULT

Using SWIFT tools:

1. Insert the W-USB dongle into your computer and launch the SWIFT Tools application.
2. On the home screen you can select Site Survey, Create Mesh Network, or Diagnostics.
3. Click Operations and select Set device to factory default.
4. You are now on the Reset Devices screen. Select the desired device, and click Reset.

 

Manually:

1. Start with the device powered off.
2. Insert one single battery into any slot in the device. The LED will blink yellow once every 5 seconds for a minute.
3. Turn the SLC address wheels using a common screwdriver to 0, then to 159, then back to 0.
4. The device will blink green five times, followed by a single or double red blink.
   This is your confirmation the device is now on factory default.

 

 

 

 

ANALYZE LINK TEST & RF SCAN DATA IN SWIFT TOOLS

 

 

For additional support
notifier.com
Customer Service:
203-484-7161
Tech Support
NOTIFIER.Tech@honeywell.com
800-289-3473

 

Read More About This Manual & Download PDF:

Documents / Resources

NOTIFIER Swift Smart Wireless Integrated Fire Detectors [pdf] User Guide Swift Smart Wireless Integrated Fire Detectors, Smart Wireless Integrated Fire Detectors, Wireless Integrated Fire Detectors, Integrated Fire Detectors

References

• User Manual