Nintendo NDK CORE Ounce Development Kit
Specifications
- Model: BEE-056
- Compliance: FCC Part 15, ISED’s RSS Standards
- Frequency Band: 5150-5350 MHz (restricted to indoor operation only)
- Compliance with FCC and ISED radiation exposure guidelines
- Class B receiver
Product Usage Instructions
- Register on the Nintendo Developer Portal to purchase the product.
- Read the NDK CORE Ounce Usage Manual available online.
- Comply with FCC and ISED guidelines for operation.
- Avoid co-locating the device and its antenna with other transmitters.
- Consult a professional for assistance if needed.
Assembly Instructions
Important: This kit is intended only for certified developers. Use indoors and follow FCC/ISED compliance (5150–5350 MHz band).
Step 1: Unbox All Components
Make sure the box includes
- Dev Kit Console (NDK CORE Ounce)
- 2 Debug Joy-Cons (tethered)
- Dual USB‑C Debug Cable (Y-shaped)
- Dock or Interface Hub
- Power Adapter (AC)
- HDMI Cable
- MicroSD Card (if included)
- Documentation
Step 2: Connect the Console
-
Attach the Debug Joy-Cons
Slide each Joy-Con onto the side rails until it clicks. These may be permanently tethered for durability/testing. -
Insert the MicroSD Card (if provided)
Open the slot under the kickstand or edge panel and insert the SD card until it locks in place.
Step 3: Connect to Interface Hub (Optional)
Plug the Dual USB‑C Cable
- Insert both ends of the Y-cable into the bottom of the dev unit.
- Connect the other end to the Nintendo dev interface hub or PC.
Power Cable to Hub or Console
- If using a dev dock/interface box, plug power into the dock.
- If connecting directly, plug the AC adapter into the device unit.
HDMI Output
-
Connect the HDMI cable from the dev unit or dock to your monitor.
Troubleshooting Tips
| Issue | Solution |
|---|---|
| No power | Check the AC adapter and USB‑C fit; confirm it’s the dev version (not retail) |
| No HDMI signal | Use only high-speed HDMI; check dev dock settings |
| Not recognized by PC | Reinstall the NDI client or drivers; use both USB‑C ends |
| Joy-Cons not responding | Some units disable them in firmware—check in NDI debug settings |
FAQs
Q: Where can I find the NDK CORE Ounce Usage Manual?
A: The manual is available in the Online Documentation section of the Nintendo Developer Portal.
Q: Can I operate the device outdoors?
A: No, the 5150-5350 MHz band operation is restricted to indoor use only.
Q: What should I do if I encounter interference issues?
A: Ensure the device is not co-located with other antennas or transmitters. Contact the manufacturer for further assistance.
Documents / Resources
 |
Nintendo NDK CORE Ounce Development Kit [pdf] Owner's Manual BEE056, BKEBEE056, NDK CORE Ounce Development Kit, CORE Ounce Development Kit, Ounce Development Kit, Development Kit, Kit |