MXR CSP041 Hybrid Fuzz
This pedal combines two iconic Fuzz Face® Distortion sounds, featuring the snarling, high-gain aggression of a silicon transistor and the smooth, shaggy warmth of a germanium transistor in a single circuit.
External Controls
- OUTPUT knob adjusts volume level of effect
- FUZZ knob adjusts intensity of effect
- FOOTSWITCH toggles effect on/bypass (red LED indicates on)
Basic Operation
Power
The MXR® Hybrid Fuzz is powered by one 9-volt battery (remove bottom plate to install), a 9-volt AC adapter such as the Dunlop ECB003/ECB003EU, or an MXR® Brick™ Series power supply.
Directions
- Run an instrument cable from your instrument to the CSP041’s INPUT jack and another cable from the CSP041’s OUTPUT jack to your amplifier.
- Start with knobs set fully counterclockwise.
- Turn effect on by depressing the footswitch.
- Rotate OUTPUT knob clockwise to increase volume or counterclockwise to decrease it.
- Rotate FUZZ knob clockwise to increase intensity of effect or counterclockwise to decrease it.
Specifications
| Input Impedance | > 15 kΩ |
| Output Impedance | < 450 kΩ |
| Max Output Level | -9.6dBU |
| Max Gain | +42 dB |
| Noise Floor | -87 dBU |
| Bypass | True Hardwire |
| Current Draw | 2.5 mA |
| Voltage Requirements | 9 volts DC |
Customer Support
Documents / Resources
 |
MXR CSP041 Hybrid Fuzz [pdf] User Manual CSP041 Hybrid Fuzz, CSP041, Hybrid Fuzz, Fuzz |
