AD192 Dante 8 Channel Output Option
Instruction Manual
Dante/AD-192revised 020222js
AD192 Dante 8 Channel Output Option
A Dante™ network is required to connect to.
Please refer to https://www.audinate.com/resources/technical-documentation for the current Dante Controller User Guide.
Sample rates up to 192kHz are supported by the Dante/AD-192 option.
The default for the Dante-192 is 48K.
Use the Dante controller software in your system to select the desired sample rate.
Clocking is determined by the Dante controller software.
The Dante/AD-192 is a Tx (transmit) device only.
Primary Connection – Use this for the main Dante network connection
Secondary Connection – Use this for redundant network configurations. Do not mix Primary and secondary connections within the same network.
Millennia Media, Spc.
http://www.mil-media.com
Indicator LEDs – The left LED on the connector indicates the connection is active and when blinking shows the unit is active on the network. The right LED indicates illuminates if the unit is connected to a 1Gbps network. Off indicates it is connected to a 100Mbps network.
FCC Notice Information for the User
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his or her own expense.
| Option | Supported |
| Latency Monitoring | Yes |
| Latency Range | 150uS-5mS |
| Identify a device by flashing LEDs | No |
| Enable Sync to external Clock | No |
| Transmit Channels | 8 |
| Receive Channels | No |
| 16 bit data | Yes |
| 24 bit data | Yes |
| 32 bit data | Yes |
| Option | Supported |
| Master Clock enable | Yes |
| Slave Clock enable | Yes (Default) |
| External Clock | No |
| Sample Rate Pull up/down | No |
| VLAN | No |
| Multicast | Yes |
| 44.1K data Rate | Yes |
| 48K data Rate | Yes (Default) |
| 88.2K data rate | Yes |
| 96K data rate | Yes |
| 176K Data Rate | Yes |
| 196K Data Rate | Yes |
| Redundant LAN | Yes (Default) |
| Switched LAN | Yes |
| Static IP | Yes |
| DHCP IP | Yes (Default) |
| Bit rate change without reboot | Yes |
| Per Channel Encoding | No |
| Device Encoding | Yes |
| Signal Metering | No |
| Unit Labeling | Yes |
| Channel Labeling | Yes |
| Supports 8 channels Tx /Flow | Yes |
| Up to 32 Unicast/Multicast Flows | Yes |
World Wide Warranty
We will repair our products, free of charge, in the event of defects of materials or workmanship for two (2) years following the date of purchase.
This limited warranty covers failures due only to defects in materials and workmanship that occur during normal, intended use and does not cover damage that occurs in shipment or failures which are caused by products not supplied by Millennia Media.
This limited warranty does not cover failures that arise from accident, misuse, abuse, neglect, mishandling, misapplication, faulty installation, improper adjustment, alteration or modification of product, incompatibilities, line-power surges, acts of God, or service performed by anyone other than Millennia Media or its authorized agent.
Limits and Exclusions – There are no express warranties except as listed above. Millennia shall not be liable for special, subsequent, incidental, consequential, or punitive damages, including, but not limited to: damage to recordings, broadcasts, microphones, mixing consoles, or any associated equipment, downtime costs, loss of goodwill, or claims of any party dealing with the purchaser for such damages resulting from the use of this product. All warranties express and implied, including the warranties of merchantability andfitness for a particular purpose are limited to the applicable warranty period set forth above.
Vacuum tube and bulb failures are not covered under warranty.
Shipping costs to/from the factory are not covered under this warranty. International warranty law may vary from country to country, and Millennia will abide by the law of each country from which the product was initially sold.
For North American repairs and services, contact Millennia (tech@mil-media.com) to obtain a Return Authorization number.
Please include your shipping address, daytime phone number and description of the problem.
Outside of North America, please contact your local Millennia Distributor.
Discarding Units
In the event that any Millennia equipment manufactured after July 1, 2006 needs to be discarded, you must return it to Millennia, at our headquarters in California, USA. Please contact the distributor in your country or Millennia directly for instructions.
We will make arrangements to have the equipment shipped to us at no cost to you, and we will dispose of it in a manner that complies with whatever regulations are in existence at that time.
Millennia Media, Spc.
http://www.mil-media.com
Diamond Springs, CA 95619
530-647-0750
Documents / Resources
 |
Millennia AD192 Dante 8 Channel Output Option [pdf] Instructions AD192, Dante 8 Channel Output Option, Output Option, Dante 8 Channel Option, Option |
