Powered byINSTALLATION

CONTENTS

MT-B01 is composed of:

1. speakers
2. control box
3. recharging cable type C
4. keypad
5. wired microphone
6. boom mike

CONTROL BOX

On the rear side of the helmet there’s a slot suitable for placing the control box.

Installation:

1. unscrew the 2 screws and remove the cover
2. Insert the control box
3. Close the cover and screw again.

SPEAKERS

Place both speakers in the deep ear pocket of your helmet (if possible). Place both speakers as much as possible close and centered to your ears.

You can hide the speaker wires under the helmet padding.
Attention: for the best sound clarity it is very important to place the speakers in correspondance with the centre of your ears and as close as possible (the speakers must almost touch your ears).

MICROPHONES

If you are using the boom microphone, fi x it on the left side and keep the sponge as close as possible to your mouth (be sure the white arrow is facing your mouth).
If you use the wired microphone for full-face helmets, fix it on your helmet in front of your mouth.

EXTERNAL BUTTON

Place the external button on the left side of your helmet using the 3M adhesive.

CHARGING

You can charge your MT-B01 using any standard USB wall adapter or PC port.
MT-B01 is supplied with a USB-C recharging cable.

Distributed by:
AXXIS Helmets
Calle Zagreb, 2
Pol. Ind. Cabezo Beaza,
30353 Cartagena – Spain.
info@axxis-helmets.com – www.axxis-helmets.com
Produced or imported by:
MIDLAND EUROPE S.R.L.
Via R. Sevardi 7
42124 Reggio Emilia – Italy.

Documents / Resources

MIDLAND MT-B01 Plug and Play Intercom System [pdf] Installation Guide 110, 150, MT-B01 Plug and Play Intercom System, MT-B01, Plug and Play Intercom System, Play Intercom System, Intercom System, System

References

• User Manual