Microflex Labs 104 Turn Signal Switch
Description
The model 104 turn signal switch provides left and right turn signal momentary switches for 2-inch diameter steering column mounting. Adapters are available for use with other common diameters.
The switch uses digital hall-eff ect sensors to detect the presence of a magnet. A magnet, mounted to the lever is moved for right or left switching. When the magnet is moved close to one of the sensors battery voltage is produced on the output. When the lever is released, it springs back to the center position and the output returns to 0 volts. There are no mechanical switch contacts to wear or corrode. Electronics are fully sealed in epoxy providing a tough weather-proof turn signal switch that can be used in wet locations, including high pressure spray washing, and has an IP68 rating.
Model 104 outputs cannot provide enough power to drive lights directly. The model 104 switch must be used with a lights controller.
The lever knob is removable to allow for a custom knob to match your vehicle design.
Features
- Sealed hall-eff ect digital switches
- Suitable for wet locations
- Can be installed without removing the steering wheel
- Billet aluminum enclosure
- Stainless-steel hardware
- Removable lever knob allows for customization
- Wide operating voltage range – can be used on 6V, 12V, and 24V systems
Specifications
Supply Power (Battery)
Minimum ………………………………………………. 5 Volts
Max ……………………………………………………. 30 Volts
Operating Current …………………………….3mA (max)
Harness
Red Wire ………………………….Battery (+), 22-Gauge
Black Wire …………………………….Ground, 22-Gauge
Yellow Wire ……. Left Turn – Lever Down, 22-Gauge
White Wire …………Right Turn – Lever Up, 22 Gauge
Cable ………………… Black PVC .20 [5mm] Diameter
Length …………………………………………..36” [900mm]
Switches
Drive Current, Each Switch ……………….20mA (max)
Open ……………………………..0.5V (max at 1Kม load)
Closed ………………………………. Supply – 0.5 V (min)
Materials
Enclosure, Lever, and Knob …….6061-T6 Aluminum
Screws ……………………………………… Stainless Steel
Electronics enclosure ………………………..ASA plastic
Environmental
Operating Temp ……. -22°F to 122°F [-30°C to 50°C]
Storage Temp ………. -40°F to 158°F [-40°C to 70°C]
Seal …………………………………………….Epoxy Potting
Weight ………………………………………………… 6oz [175g] IP Rating ………………………………………………………….68
QR Code
Disposal
Microfl ex Labs 35900 Royal Road Pattison, Texas 77423 USA
RideLightSolution.com
Documents / Resources
![]() |
Microflex Labs 104 Turn Signal Switch [pdf] Owner's Manual 104 Turn Signal Switch, 104, Turn Signal Switch, Signal Switch, Switch |