MEAN WELL LRS-100 Series Single Output Switching Power Supply User Guide

LRS-100 Series Single Output Switching Power Supply

Specifications

Model DC Voltage Rated Current Current Range Rated Power Ripple & Noise (max.) Output Setup, Rise Time Hold Up Time (Typ.) Voltage Range Frequency Range Efficiency (Typ.) AC Current (Typ.) Inrush Current (Typ.)
LRS-100-3.3 3.3V 20A 0 ~ 20A 66W 100mVp-p 500ms, 30ms/230VAC 500ms,30ms/115VAC at full load 55ms/230VAC 10ms/115VAC at full load 85 ~ 264VAC 120 ~ 373VDC (Withstand 300VAC surge for 5sec.
Without damage)
47 ~ 63Hz 84.5% 1.9A/115VAC 1.2A/230VAC 50A/230VAC COLD START

Product Usage Instructions

1. Installation

Ensure the input voltage matches the specified voltage range.
Connect the output wires to your device following proper
polarity.

2. Powering On

After installation, switch on the power supply by connecting it
to a power source and turning on the power switch.

3. Adjusting Output

To adjust the output voltage or current, use the provided
controls on the power supply unit according to your device’s
requirements.

4. Safety Precautions

Always follow electrical safety guidelines when working with the
power supply unit to prevent electric shock or damage to the
unit.

Frequently Asked Questions (FAQ)

Q: What should I do if the power supply unit gets
overheated?

A: If the unit overheats, immediately turn it off and disconnect
it from the power source. Allow it to cool down before attempting
to use it again.

Q: Can I use the power supply with devices that have different
voltage requirements?

A: It is recommended to match the voltage and current
specifications of the power supply with those required by your
device to avoid damage.


“`

100W Single Output Switching Power Supply

LRS-100 series
User’s Manual

IS 13252

THOMAS SAMUEL

THOMAS SAMUEL

(NOTE 9)

AS/NZS62368-1 GB 4943.1

UL62368-1

Bauar t gepruft Sicherheit
egelma ge od o s be wac g
www. tuv.com ID 2000000000

TP TC004 IEC62368-1

(for LRS-100-12/24 only)

Downloaded from Arrow.com.

File Name:LRS-100-SPEC 2025-04-07

100W Single Output Switching Power Supply

LRS-100 series

SPECIFICATION
MODEL

LRS-100-3.3 LRS-100-5 LRS-100-12 LRS-100-15 LRS-100-24 LRS-100-36 LRS-100-48

DC VOLTAGE

3.3V

5V

12V

15V

24V

36V

48V

RATED CURRENT

20A

18A

8.5A

7A

4.5A

2.8A

2.3A

CURRENT RANGE

0 ~ 20A

0 ~ 18A

0 ~ 8.5A

0 ~ 7A

0 ~ 4.5A

0 ~ 2.8A

0 ~ 2.3A

RATED POWER

66W

90W

102W

105W

108W

100.8W

110.4W

RIPPLE & NOISE (max.) Note.2 100mVp-p

100mVp-p

120mVp-p

120mVp-p 150mVp-p

200mVp-p

200mVp-p

OUTPUT

VOLTAGE ADJ. RANGE 2.97 ~ 3.6V VOLTAGE TOLERANCE Note.3 ±3.0% LINE REGULATION Note.4 ±0.5% LOAD REGULATION Note.5 ±2.0%

4.5 ~ 5.5V ±2.0% ±0.5% ±1.0%

10.2 ~ 13.8V ±1.0% ±0.5% ±0.5%

13.5 ~ 18V ±1.0% ±0.5% ±0.5%

21.6 ~ 28.8V ±1.0% ±0.5% ±0.5%

32.4 ~ 39.6V ±1.0% ±0.5% ±0.5%

43.2 ~ 52.8V ±1.0% ±0.5% ±0.5%

SETUP, RISE TIME

500ms, 30ms/230VAC 500ms,30ms/115VAC at full load

HOLD UP TIME (Typ.) 55ms/230VAC 10ms/115VAC at full load

VOLTAGE RANGE

85 ~ 264VAC 120 ~ 373VDC (Withstand 300VAC surge for 5sec. Without damage)

FREQUENCY RANGE 47 ~ 63Hz

INPUT

EFFICIENCY (Typ.) AC CURRENT (Typ.)

84.5%

86%

88%

1.9A/115VAC 1.2A/230VAC

88.5%

90%

90.5%

91%

INRUSH CURRENT (Typ.) COLD START 50A/230VAC

LEAKAGE CURRENT

<0.75mA / 240VAC

OVER LOAD
PROTECTION OVER VOLTAGE

110 ~ 150% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 3.8 ~ 4.45V 5.75 ~ 6.75V 13.8 ~ 16.2V 18.75 ~ 21.75V 28.8 ~ 33.6V 41.4 ~ 48.6V Protection type : Shut down o/p voltage, re-power on to recover

WORKING TEMP.

-30 ~ +70 (Refer to “Derating Curve”)

WORKING HUMIDITY

20 ~ 90% RH non-condensing

ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85, 10 ~ 95% RH non-condensing

TEMP. COEFFICIENT

±0.03%/ (0 ~ 50)

55.2 ~ 64.8V

VIBRATION

10 ~ 500Hz, 5G 10min./1cycle, 60min. each along X, Y, Z axes

OVER VOLTAGE CATEGORY

; Compliance to BS EN/EN61558, BS EN/EN50178, BS EN/EN60664-1, BS EN/EN62477-1; altitude up to 2000 meters

SAFETY STANDARDS

UL 62368-1, TUV BS EN/EN62368-1, BS EN/EN60335-1, BS EN/EN61558-1/-2-16,GB 4943.1, BSMI CNS15598-1, EAC TP TC 004,S/NZS62368.1(by CB),KC K60950-1(for LRS-100-12/24 only), BIS IS13252(Part1): 2010/IEC 60950-1: 2005(NOTE 9) approved

SAFETY & WITHSTAND VOLTAGE

EMC

ISOLATION RESISTANCE

(Note 8)

EMC EMISSION

I/P-O/P:4KVAC I/P-FG:2KVAC O/P-FG:1.25KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25/ 70% RH
Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/EN55014, BS EN/EN61000-3-2,-3, GB17625.1,GB/T 9254.1, BSMI CNS15936, EAC TP TC 020,KC KN32,KN35(for LRS-100-12/24 only)

EMC IMMUNITY

Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN61000-6-2 (BS EN/EN50082-2),BS EN/EN55035, heavy industry level, EAC TP TC 020,KC KN32,KN35(for LRS-100-12/24 only)

MTBF

3348.9K hrs min. Telcordia SR-332 (Bellcore) ; 677.4Khrs min. MIL-HDBK-217F (25)

OTHERS DIMENSION

129*97*30mm (L*W*H)

PACKING

0.33Kg ; 40pcs/14.2Kg/0.87CUFT

NOTE

(as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)
9. Some model may not have the BIS logo, please contact your MEAN WELL sales for more information. , https://www.meanwell.com/serviceDisclaimer.aspx

File Name:LRS-100-SPEC 2025-04-07

Downloaded from Arrow.com.

100W Single Output Switching Power Supply

LRS-100 series

Block Diagram

I/P

EMI FILTER

FG

Derating Curve

RECTIFIERS &
FILTER
O.L.P.

POWER SWITCHING
CONTROL

RECTIFIERS &
FILTER
DETECTION CIRCUIT
O.V.P.

Static Characteristics

fosc : 65KHz
+V -V

100

Others

80

60

3.3V,5V

40

20

-30

0

10 20 30 40 45 50 60

70 (HORIZONTAL)

AMBIENT TEMPERATURE ()

100 90 80 70 60 50 40
85 95 100 115 120 140 160 180 200 220 240 264
INPUT VOLTAGE (VAC) 60Hz

LOAD (%) LOAD (%)

Downloaded from Arrow.com.

File Name:LRS-100-SPEC 2025-04-07

100W Single Output Switching Power Supply

LRS-100 series

26 15 6 18 3.5 14.5
30

3-M3 L=5 3.5

33

Mechanical Specification

4.5

122.5

9.5

3.5 1 2 3 4 5 6 7

8

LED SVR1
78 129

6.5

120

2-M3 L=3.0

34

32

77

Installation Manual
Please refer to : http://www.meanwell.com/manual.html

3.5

6.5

85

97

Case No.238A Unit:mm Tolerance:±1

Terminal Pin No. Assignment

Pin No. Assignment Pin No.

1

AC/L

4,5

2

AC/N

6,7

3

FG

Assignment DC OUTPUT -V DC OUTPUT +V

Downloaded from Arrow.com.

File Name:LRS-100-SPEC 2025-04-07

Documents / Resources

MEAN WELL LRS-100 Series Single Output Switching Power Supply [pdf] User Guide
LRS-100-3.3, LRS-100-5, LRS-100-12, LRS-100-15, LRS-100-24, LRS-100-36, LRS-100-48, LRS-100 Series Single Output Switching Power Supply, LRS-100 Series, Single Output Switching Power Supply, Output Switching Power Supply, Switching Power Supply, Power Supply

References

Leave a comment

Your email address will not be published. Required fields are marked *