Installation  Manual

Safety Instructions

Please read this notice carefully and keep it all along the use of this product. Follow the instructions for a safe and correct installation and functioning of the fitting.The manufacturer does not accept any responsibility for damage caused by improper installation and service. Always isolate the power before commencing installation, maintenance or repair.
In case of doubts, please contact a qualified electrician.This product is for indoor use only. Please do not use it on humid places. Do not put it in contact with water or any liquids or inflammable products. Always respect the minimal distance (indicated on the light) to inflammable products.
During installation, make sure that the cables will not be squeezed or damaged by sharp edges. If the external flexible cable is damaged, it needs to be replaced exclusively by the manufacturer, his service agent, or another qualified electrician. This is to avoid all risks.

1. Fix Metal Bracket tothe ceiling
2. assemble the metal rod
3. adjust the length of cable and tigten the srews
4. add Plastic Anchor on the wire inside Canopy
5. Connect wires
6. 1 pls hang the pendants C1&C2as picture showed on 1st layer
   6.2 pls hang the pendants B1&B2as picture showed on 2nd layer
   6.3 pls hang the pendants A1&A2as picture showed on 2nd layer

Documents / Resources

Marshall-Tufflex C1 and C2 Sterling Curve Trunking [pdf] Installation Guide C1 and C2 Sterling Curve Trunking, C1 and C2, Sterling Curve Trunking, Curve Trunking, Trunking

References

• User Manual