Lumens VS-KB30 Joystick Firmware(FW)
Please contact Lumens FAE Department through email to get the proper F W and AP before upgrading.
Device and Tool Preparation
FW of VS-KB30
Type | Version and Extension |
Master | 0.x.xL.bin / |
Webpage(IP) | V2.x.x.csf/ VA.x.x.img |
Please do not change the file name and extension. Wrong file information may cause the FW upgrade failed and unit not work.
Master firmware update
FW File: 0.x.xL. bin
Note: Wrong file extension will cause the FW upgrade failed.
- Save master firmware to USB flash disk
- Save the “.bin” firmware file in the root directory (not inside of a folder)
- Place the flash drive into the USB port on the back panel of the VS-KB30
- Hold down the L/R Direction knob and click the power button into the “On” position.
- The keyboard will display a confirmation that the upgrade is starting. (around 10 secs)
- When keyboard shows “FIRMWARE UPGRADE SUCCEED”, power off unit and reboot.
Webpage firmware update
FW File: V2.x. x. cs f or V A.x.x.img
Note: V2.x.x can’t upgrade to V A.x.x due to the hardware limitation. Please do not change the file name and extension which will cause the FW upgrade failed.
- Set your PC or laptop and VS-KB30 in the same network.
- Type IP address of VS-KB30 on browser to access the login page.
- User:admin
- Password:default is empty
- Follow the instruction to upload webpage firmware from PC or laptop.
- Press start to upgrade the webpage firmware.
- When keyboard shows “FIRMWARE UPGRADE SUCCEED”, power off unit and reboot.
Check the firmware version.
- Press “SETUP”, [KEYBOARD SETTING]=>[MODEL INFO] to confirm the firmware version.
Documents / Resources
![]() |
Lumens Lumens VS-KB30 Joystick Firmware(FW) Upgrade [pdf] Instructions Lumens, VS-KB30, Joystick, Firmware, FW, Upgrade |