LIGHT and MOTION 800-0418-A Goodman Handle
Product Information
- Product Name: Goodman Handle
- Model Number: 800-0418-A
- Compatibility: Sola 2L Mounting
- Additional Accessory: Ball Mount Thumb Screw (Sold Separately) Part # 800-0438-A
Product Usage Instructions
- Mounting Plate Placement
- Position the mounting plate between the Goodman Handle frame with the recess slot for bolt heads facing downwards.
- For left-hand use, position the thumb rest on the right side and insert the mounting plate with the extended slot facing back towards your arm.
- Thumb Screw Installation
Secure the plate position by tightening both thumb screws. - Bungee Cord Attachment
- Feed the open end of the bungee cord through the hole in the bottom of the thumb rest and tie an overhand knot, pulling the knot into the hole.
- Once the fit is confirmed, cut the tail of the cord with scissors. Ensure to hold the end under a flame to seal it from unraveling.
- Sola 2L Mounting
Remove mounting accessories from the Goodman Handle.
Learn more at support.lightandmotion.com
FAQ
Q: What should I do if I need to purchase additional accessories like the Ball Mount Thumb Screw?
A: You can purchase the Ball Mount Thumb Screw separately with Part # 800-0438-A. Contact our customer support for assistance.
Mounting Instruction
- Step 1. Mounting Plate Placement:
- Position the mounting plate between the Goodman Handle frame with the recess slot for bolt heads facing downwards.
- For the left hand: position the thumb rest on the right side and insert the mounting plate with the extended slot facing back – toward your arm.
- Step 2. Thumb Screw Installation:
- Secure the plate position by tightening both thumb screws.
- Secure the plate position by tightening both thumb screws.
- Step 3. Bungee Cord Attachment:
- Feed the open end of the bungee cord through the hole in the bottom of the thumb rest and tie an overhand knot, pulling the knot into the hole.
- Once the fit is confirmed, cut the tail of the cord with scissors. Make sure to hold the end under a flame to seal it from unraveling.
- Step 4. Sola 2L Mounting:
- Remove mounting accessories from your Sola.
- Attach the ¼-20 mount adapter to the Goodman handle plate using the ¼-20 bolt. Make sure the tab with the hole is facing forward.
- Slide your Sola light onto the mount adapter from the back to the front until the adapter tab hole lines up with the threaded insert on the Sola body.
- Screw in the 10-32 with washer through the Goodman handle plate into the threaded insert in the Sola. Do not over-tighten.
Note: Refer to the exploded view for part identification.
Learn more at support.lightandmotion.com.
Documents / Resources
 |
LIGHT and MOTION 800-0418-A Goodman Handle [pdf] Instructions 905-0497-A, 800-0418-A, 800-0418-A Goodman Handle, 800-0418-A, Goodman Handle, Handle |
