LCDWIKI E32R28T 2.8inch ESP32-32E Display Module
Product Information
- Model: LCDWIKI 2.8inch ESP32-32E E32R28T&E32N28T
- Quick Start Manual: CR2024-MI2875
- Display Module: 2.8inch ESP32-32E
- Manufacturer: LCDWIKI
- Website: www.lcdwiki.com
Specifications
- Display Size: 2.8 inches
- Model: ESP32-32E E32R28T&E32N28T
- Interface: Type-C cable
- ChipType: ESP32
- SPI SPEED: 80MHz
- SPI MODE: DIO
Power on the Product
- Use the Type-C cable with power supply and data transmission function to connect the computer to the product and power the product.
- As shown in the picture below:
Install the USB-to-serial port driver
- Locate the USB-SERIAL_CH340.zip package in the “7-T.***1_Tool_software” folder and decompress it.
- Go to the folder after decompression, double-click the “CH341SER.EXE” executable program, pop up the installation window, and then click the “Install” button to continue the installation, as shown in the following picture:
- After the installation is successful, click the window OK button to exit. Connect the computer USB to the development board powerpoint n, and then enter the computer device manager, you can see that the CH340 port is identified under the port, as shown in the following picture:
Burn the bin file
- A. Open the “Flash_Download” folder in “8-EH_Quick_Start”, ‘, locate the “flash_download_tool” folder, open the folder, and double-click the exe executable file of flash_download _tool. As shown in the picture below:
- B. After opening the Flash download tool, Chip Type select “ESP32”, WorkMode select “Develop”, LoadMode keeps the default (UART), and then click the “OK” button, as shown below:
- C. Enter the Flash download tool interface, first select the bin file to burn, binthee ile in the data package “8-t*ifF_Quick_Start /bin” directory, as shown in the following figure:
- D. Click the button with three dots in the middle to select the bin file in the above steps. After the selection, check the box in the front and set the burning address as “0”, as shown in the following picture:
- E. Set SPI SPEED to “80MHz”, SPI MODE to “DIO”, and keep other Settings default, as shown in the following figure:
- F. Set COM, as long as the product is normally connected to the computer, Cthe OM port will be automatically recognized, click the drop-down menu to select.
- Set BAUD, and click the drop-down menu to select, the larger the value, the faster the burning speed, but can not exceed the maximum transmission rate supported by the USB-to-serial chip. As shown in the picture below:
Run the program
After the Bin file is burned, press the reset button of the product or power on the product again, and you can see the operation effect of the program, as shown in the figure below:
Frequently Asked Questions
Q: How can I check if the product is successfully powered on?
A: You can verify successful power-on by observing the display or checking the device manager for port recognition.
Q: What should I do if the bin file burning process fails?
A: Double-check the settings, ensure a stable connection, and try burning the bin file again.
Documents / Resources
 |
LCDWIKI E32R28T 2.8inch ESP32-32E Display Module [pdf] User Guide E32R28T 2.8inch ESP32-32E Display Module, E32R28T, 2.8inch ESP32-32E Display Module, ESP32-32E Display Module, Display Module, Module |