Konix WF01 Wireless Transceiver
Product description
- WF01 is a digital U-segment wireless transceiver newly developed by our company with high fidelity, low delay, and strong anti-interference ability.
- It has the advantages of small size, high integration, good sound quality, wide input voltage range (2.4- 6V), etc. It works in the mode of fixed ID.
- WF01 is a high-quality digital wireless product suitable for speakers, headphones, microphones, and electric wind instruments.
Product introduction
Product specification
- Transmit power: <25mw
- Reception sensitivity: -95dB
- System frequency response: 30Hz—18KHz
- Latency:<3ms
- Sampling rate: 48 KHz
- Signal-to-noise-ratio: 90dB
- Distortion: <0.5 TDH
- Dynamics range: >90dB
- Working current: transmitter:<90mA,
- receiver: <110mA
- Transmission distance: Straight line distance 50m.
Product function
- Pairing:
- It has been paired before delivery. If you need to re-pair, the operation is as follows:
- Press the “Pairing button”of the transmitter till the red light is flashing enter to pair, then press the “Pairing button”of the receiver till the red and blue light flash alternately, repress the “Pairing button”of the transmitter the receiver lights up blue.
- Low battery alarm:
- The red light flashes slowly when the transmitter is low. The red and blue light flash slowly alternately when the receiver is low.
- Charging indicator:
- When charging lights are red, full lights are green
- TYPE-C charging interface.
- With a built-in 700mA Li-battery.
FCC Warning Statement
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Documents / Resources
 |
Konix WF01 Wireless Transceiver [pdf] Instruction Manual 2AX4N-WF01, 2AX4NWF01, wf01, WF01 Wireless Transceiver, WF01, Wireless Transceiver, Transceiver |