JEGS H11 Can Bus Xenon HID Kit
INSTALLATION
- DISCONNECT THE VEHICLE’S BATTERY NEGATIVE TERMINAL
- REMOVE THE DEM HALOGEN BULB FROM THE BULB SOCKET
- INSTALL THE XENON BULB IN PLACE OF THE HALOGEN BULB
- MOUNT THE XENON BALLAST WITH SUPPLIED BRACKETS
- CONNECT EACH OF THE CORRESPONDING WIRE JUNCTIONS
- IF NECESSARY, DRILL A HOLE IN THE BACK CAP FOR THE GROMMET
- CONNECT BATTERY AND TEST SYSTEM, INSTALL HARNESS IF NECESSARY
- BULB WIRE
- BALLAST CONNECTION
- HARNESS TO FACTORY
- FACTORY CONNECTOR
Documents / Resources
 |
JEGS H11 Can Bus Xenon HID Kit [pdf] Installation Guide H11 Can Bus Xenon HID Kit, H11, Can Bus Xenon HID Kit, Xenon HID Kit, HID Kit |