Insta360 CINSBAHC Standard Lens Guards For X5 Action Camera
How to Use
Install the Lens Guards
Align the notch on the Lens Guards with the lower right slot of the lens, as shown below. Then, rotate the Lens Guards clockwise until the notch is aligned with the microphone.
Confirm installation
After the Lens Guard is installed on the screen side, an
icon will appear in the camera’s status bar, followed by a pop-up message. Tap the prompt to confirm.
Remove the Lens Guards
Hold down the edge of the base of the Lens Guards as shown and rotate counterclockwise to remove. After removal, the icon on the status bar will disappear.
Notes
- Do not squeeze or pull the base too hard when installing the Lens Guards, as this may change the shape or damage the base.
- Ensure the Lens Guards are securely installed on both lenses before using the camera. Remember, the notch on the Lens Guards must be aligned with the camera’s microphone.
- If the notch isn’t aligned, the camera cannot auto-recognise the Lens Guards.
- Only after the Lens Guard is installed on the screen side will the icon display on the camera’s status bar, and the prompt appear.
- If you install the Lens Guards while the camera is recording, saving, updating or formatting, the camera will display the status icon but not the prompt.
- The Lens Guards may slightly affect the camera’s stitching. For best results, always try to point one lens at the subject.
- Dirty or worn Lens Guards may affect the final image result.
- Avoid using the Lens Guards in rain or water sports due to the non-sealed structure.
- To avoid fogging, dry the Lens Guards thoroughly with a soft cloth if exposed to rain, snow or fog.
- The Lens Guards contain magnets. Keep them away from pacemakers and other devices to prevent interference.
Disclaimer
Please read this Disclaimer carefully. Using this product means that you acknowledge and accept the terms of this disclaimer. By using this product, you hereby acknowledge and agree that vou are solely responsible for your conduct when using this product
and any consequences thereof. You agree to use this product only for proper and lawful purposes.
You understand and agree that Arashi Vision Inc. (hereinafter referred to as ‘Insta360’) accepts no liability for any misuse, consequences, damages, injuries, penalties, or any other legal responsibility directly or indirectly incurred by your use of this product and associated accessories. Before every use, make sure that your accessories are functioning properly. If there’s any damage or irregularity, stop using them immediately. Within the scope of state laws and regulations, Insta360 reserves the right to final explanation and revision for the commitment.
After-Sales Service
The warranty period of the attached product is 3 months from the original retail purchase. Warranty service may vary according to the applicable laws of your state or jurisdiction. For detailed warranty policies, please visit https://insta360.com/support.
Arashi Vision Inc.
TEL /：400-833-4360
WEB / Ex]: www.insta360.com
EMAIL / m3xễ : service@insta360.com
ADDRESS
111f 11th Floor, Building 2, Jinlitong Financial Centre
Baoan District, Shenzhen, Guangdong, China
Arashi Vision (U.S.) LLC
TEL: +1 800 6920 360
WEB: www.insta360.com
EMAIL: service@insta360.com
ADDRESS: 2323 Main St, Unit 16, Irvine, CA 92614, United States
Insta360 GmbH
TEL: +49 302 215 20255
WEB: www.insta360.com
EMAIL: service@insta360.com
ADDRESS: Gartenfelder Straße 29-37, Gebäude 31/31.12
1.0G, 13599 Berlin, Germany
Documents / Resources
 |
Insta360 CINSBAHC Standard Lens Guards For X5 Action Camera [pdf] Instruction Manual CINSBAHC, 842126109775, CINSBAHC Standard Lens Guards For X5 Action Camera, CINSBAHC, Standard Lens Guards For X5 Action Camera, For X5 Action Camera, Action Camera, Camera |