IDOR 433-868MHZ 2 Channel Multi Code Receiver
RX Multi Picture
Brand selector
With 8 8-bit dip switches, the user can make different combinations for different remote brands. The brand selection is shown in the below table.
In RX–Multi receiver, there are 2 independent channels. Each channel has independent learn buttons S1, S2, and L1, L2. 000000
Power Input Selector
- This receiver can work at AC/DC 12V~30V. However, it’s better to change the PIS according to the power input.
- If the input is great than 24V, shorten pin 2&3; shorten 1&2 if input less than 24V.
Exchangeable Memory Card
The memory card can be removed from the board for reading, copying, and backup.
Programming procedure
- First, select the correct brand for the remote that will be entered (by dip switch).
- Press the learn button, LED turns on.
- Press the button on the remote, and the LED $1/52 flashes 4 times, this remote button enters into the RX-MULTI successfully.
- Repeat step 2 for another button.
- Both channels work the same.
Erase all data in the memory card.
Pressing and holding either learn button, the LED starts to flash. Keep pressing this button until the LED turns off. All data in the memory card will be erased permanently.
Notice: Be careful about erasing all data in the memory card. The data will be erased permanently and cannot be recovered.
Documents / Resources
 |
IDOR 433-868MHZ 2 Channel Multi Code Receiver [pdf] Instructions RX-Multi-433, RX-Multi-868MHZ, 433-868MHZ 2 Channel Multi Code Receiver, 433-868MHZ, 2 Channel Multi Code Receiver, Multi Code Receiver, Code Receiver, Receiver |