HYCHIKA CB2000 Combination Slide Bolt
Included Components
Recessed Mounting
- Step 1 Position the Strike Plate in its intended position. The 5/8” cutout in the Strike Plate must be over a recess in the door frame.
- Step 2 Mark the positions for the screws on the mounting surface.
- Step 3 Drill pilot holes for the screws.
- Step 4 Screw the Strike Plate into place with the included One-Way Screws.
Flush Mounting
- Step 1 Complete Steps 1-3 above, then continue to Step 2 below.
- Step 2 Hold the Combi-Bolt slide bolt latch in its intended position, then mark the positions for the screws on the mounting surface.
- Step 3 Drill pilot holes for the screws.
- Step 4 Screw the Combi-Bolt into place using the included One-Way Screws.
- Step 5 Install the Bolt Receiver. Before screwing in the One-Way Screws be certain the Bolt slides smoothly into the Bolt Receiver.
Using Instructions
Combi-Bolt (inches)
Bolt Receiver for Flush Mounting
Strike Plate for Recessed Mounting
Recessed Mounting
Flush Mountain
WARNING: This product can expose you to chemicals including chromium, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Contact
Documents / Resources
 |
HYCHIKA CB2000 Combination Slide Bolt [pdf] Instruction Manual CB2000 Combination Slide Bolt, CB2000, Combination Slide Bolt, Slide Bolt, Bolt |