HDWR RS2322D QR Code Reader User Manual

Beep Settings: Mute enabled, Loud beep, Silent signal sound
Settings: Interface settings, Barcode scanning modes, Light signal settings, Beep settings, Prefix and Suffix settings

Product Usage Instructions

Entering Setup Mode:
Before setting any function, scan the Entering Configuration Mode code to enter the setup mode.

Exiting Setup Mode:
To exit setup mode, scan the Exit Configuration Mode code.

Restoring Factory Settings:
To restore factory settings, scan the appropriate code for restoring settings.

Saving Default Settings:
To save the current configuration as default settings, scan the Save the current configuration as Default settings code.

Restoring Default User Settings:
To restore default user settings, scan the Restore user default settings code.

FAQ

How do I change the scanning mode?
To change the scanning mode, scan the corresponding code for Continuous or Auto mode as per your requirement.
How do I adjust the delay time between barcode scans?
Scan the appropriate code for setting the desired time delay between barcode scans (e.g., No delay, 500ms, 1000ms).

Specifications

Warranty: 2 years
Color: Black

Material: ABS
Light Source: LED

Sensor: CMOS
Resolution: 644×488

Scanning method: when the code is brought close (automatically)
Scan acknowledgement: beep

Scan speed: 200 scans/second
Scanning Angle: 360 degrees

Power supply: 5V
Interface: RS232, Virtual COM

Drop resistance: up to 1.6 meters
Device dimensions: 8 x 6.8 x 5.3 cm

Package dimensions: 17 x 9 x 6 cm
Device weight: 135 g
Package weight: 170 g
1D Readable Codes: EAN-13, EAN-8, UPC-A, UPC-E, CODE 128, CODE 39, CODE 93, CodaBar, Interleaved 2 of 5 (ITF), Industrial 2 of 5, Matrix 2 of 5, CODE 11, MSI Plessey, RSS-14, RSS-Limited, RSS-Expanded
2D Scanned Codes: QR, DataMatrix, PDF417, Micro QR, HanXin

Set contents

Wired Multidimensional Code Reader
RS232 cable
Instruction manual in paper English
User manual in electronic form in Polish

Features

Scanning: when you hold the code (automatically)
Scan speed: 200 scans/second
Types of barcodes scanned: 1D and 2D barcodes (e.g., QR) from printed labels and phone screens
Drop resistance: up to 1.6 meters

Master codes

Before setting any function, you need to scan the “Entering Configuration Mode” code first, and after setting it, it is necessary to read the “Exit Configuration Mode” code.

The device gives you the option to save the settings used as default settings. To do this, scan the code “Save the current configuration as default”. After reading the “Restore user default settings” code, you can return to the configuration set by the user.

Interface settings

Barcode scanning modes

Time delay between barcode scans

Setting the delay time for scanning a repeating barcode

Light signal settings

Backlight

Led

Dative

Beep settings

Scanning reversed codes

Setting Prefix and Suffix

Setting End Characters

Save and cancel settings

After scanning the numeric or alphanumeric code in Appendix 1, scan the “Save” code to save the settings. By scanning the appropriate code below, you can cancel the setting of one digit, the entire sequence of added digits, and cancel the current settings.