GUNNER S-M Kennels Chew Kit

INSTALLATION INSTRUCTIONS

1. To install the Chew Kit on the door place grate over windows and align the screw holes. Install the ten screws to secure the grate in place.
   
2. Repeat for bottom of door.
   
3. To install the Chew Kit on the windows use a 3/16″ hex key to remove 3 cap screws.
   
4. Using a 7/16″ wrench or ratchet, remove the bolts and washers, fastening the upper and lower halves of the kennel.
   
5. Uninstall the window pane screws to install the Chew Kit from the inside of the kennel.
   
   Line up the existing holes with the original kennel hardware.
   
6. Repeat step 5 and 6 for all five window panes.
   
7. Reinstall the upper and lower halves of the kennel. Finally, reinstall three cap screws and washers in the door frame.
   

1-844-GUNNERK • info@gunner.com

Documents / Resources

GUNNER S-M Kennels Chew Kit [pdf] Instruction Manual S-M Kennels Chew Kit, Kennels Chew Kit, Chew Kit, Kit

References

• User Manual