GREZZLE Chargelab Connect Smart
Connect Grizzl-E Smart to ChargeLab
Note: Ensure Firmware Version 5.53 or later is installed on Grizzl-E Smart before connecting to ChargeLab.
- Plug in the Charger. Ensure indicator light is alternating Blue and Purple. Ensure the unit is disconnected from the network.
- Open the Wi-Fi settings on your smartphone or desktop.
- Select the network UC_Smart_
[ChargerSerial#]. Find the Charger Serial Number on the white label on the side of the Grizzl-E Smart.
- Open the browser on your phone or desktop.
- Enter the IP address 192.168.4.1 into the browser search bar. A webpage will load.
- Select the Show Available Networks button.
- Find your Wi-Fi Network on the list of available networks. Ensure you can see the network and that Rssi is between -50 and -79.
- Select the Wi-Fi network from the list of available networks. This should highlight the network.
- Close the Available Networks box and select the Enter Credentials button. The network you selected should be pre-populated in the SSID field.
- Type the Wi-Fi password into the Password field.
- Select ChargeLab from the List of portal providers.
- Enable the Public Use checkbox.
- Select the Enter Credentials button.
- Wait 30 seconds to verify that your device is connected. If the connection is successful the indicator light will alternate between Blue and Cyan
- Disconnect your device from UC_Smart_#### and re-connect to your local network.
Application
90 Gough Road, Unit 2 Markham, Ontario L3R 5V5 Canada+1-833-840-4970
info@unitedchargers.com
www.grizzl-e.com
Documents / Resources
 |
GREZZLE Chargelab Connect Smart [pdf] Instructions Chargelab Connect Smart |
