gembird FC-K500 Computer Case Fornax Instruction Manual

Before installing the device, check the list of components and their condition. In case of problems, contact the seller.
To avoid personal injury and/or equipment damage do not insert objects or body parts into the device while it is operating

Check wiring diagrams to avoid short circuits and/or damage equipment.
Do not block the air inlets and outlets.

Keep the device away from heat sources, sunlight, water and oils. Do not use in a high humidity environment. Place it on a stable, flat and vibration-free surface in a well-ventilated room.
Do not clean with chemicals or wet cloths (chemicals: bleach, wax, benzene, alcohol, solvent, mosquito repellent, perfumes, lubricants).

Wear protective gloves when handling the device to avoid cuts and injuries.

A: Package details

Motherboard screw

The power screw
HDD screw

Copper pillar

B: Schematic diagram of wire interface

Please refer to the manual that came with your motherboard for any specific connection instructions

C: IO panel introduction

D: Chassis disassembly diagram

E: Remove and install glass side panels

Metal side plate installation: buckle the side plate and fix it with two screws

F: The power supply installation

The power supply can be fixed by aligning the screw in the figure to the hole position(ATX PSU :max length205mm)
Note: different types of power supply, hole location may be slightly different, take the actual object as the standard.

G: Motherboard installation

According to the motherboard type (ATX/M-ATX/ITX), the copper pillars may need to be re-arranged manually according to the fixing locations specific to your motherboard