GEBC ANT-9-BLE-GE Bluetooth Microwave Fixture Sensor
SPECIFICATION
The ANT-9-BLE-GE uses microwave motion detector architecture technology for improved detection coverage for high bay applications.
OVERVIEW
- Microwave sensor.
- Bluetooth® SIG mesh.
- High-End Trim, Zoning, Continuous Bi-level Dimming.
- LED Motion indicator.
- Mounting height up to 40 ft .
- 360° coverage pattern.
- Low Voltage connector.
- Technology Partner GEBC.
FEATURES AND BENEFITS
- Bluetooth to 0-10V signal converter, Bluetooth® mesh network.
- Built-in 20mA 0-10V signal output.
- A mesh network, which has a much longer control distance, transmits received signals to neighboring devices.
- All devices on the 0-10V line are broadcast controlled by mobile application.
- In a typical outdoor environment, the typical range for wireless communication is 131ft(40m).
- Actual range is dependent on field installation.
- Remote reset(press “RESET”+” ON/OFF” buttons in sequence).
- On-board antenna.
TECHNICAL DATA
SENSOR COVERAGE
WIRING DIAGRAMS
ANT-9-BLE-GE wiring with dimming ballast or LED driver
ANT-9-BLE-GE Wiring by AC/DC Adapter with dimming ballast or led driver.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection harmful interference in a radiate radio frequency energy and, if not installed and used in accordance with the instructions, ma cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
RF warning for Mobile devices:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.
ORDERING INFORMATION
- ANT-9-BLE-GE
- Bluetooth Microwave Fixture Sensor
Documents / Resources
 |
GEBC ANT-9-BLE-GE Bluetooth Microwave Fixture Sensor [pdf] Instruction Manual 2AVMOANT, 2AVMOANT ant, ANT-9-BLE-GE Bluetooth Microwave Fixture Sensor, ANT-9-BLE-GE, Bluetooth Microwave Fixture Sensor, Microwave Fixture Sensor, Fixture Sensor, Sensor |