PTX5 v1 TrioCode Remote
“
Product Information
Specifications
- Product Name: Motorized Door Opener
- Model Number: XYZ-1000
- Power Source: Electric
- Compatibility: Compatible with remote controllers
Product Usage Instructions
Deleting All Remotes from the Motor
- Disconnect the power to the motor at the power socket.
- Hold down the Door Code or SW1 button on the motor.
- While holding the button, reconnect power to the motor. The LED
will light up after a few seconds, indicating the memory is
cleared. - Release the button and test the remote. It should no longer
operate the door.
IMPORTANT: If the remote didn’t program, some
models may have a full memory which prevents adding new remotes.
You will need to delete all existing remote codes as explained in
the instructions, then reprogram each remote (old and new) one by
one.
FAQ
Q: Why is it important to delete all existing remote codes
before reprogramming?
A: Deleting all existing remote codes ensures
that the memory is cleared and there are no conflicts or
limitations when adding new remotes. This step helps in proper
reprogramming and functionality of the motorized door opener.
Q: What should I do if the remote still doesn’t work after
following the deletion process?
A: If the remote does not work after deleting
all remotes and reprogramming, check the battery of the remote,
ensure it is within range of the motor, and repeat the programming
process carefully. If issues persist, contact customer support for
further assistance.
“`
Programming a Remote via the Motor/Receiver 1. If your garage motor has a plastic cover over the buttons, please remove it. 2. Press and hold the blue Door Code button on the motor, or the SW1/SW2 button on the receiver board (keep it held down). 3. Press the button on the new remote you want to use for two seconds. 4. Release the button, wait two seconds, then press the same button again for another two seconds. 5. Release the Door Code or SW button from the motor or receiver. 6. Press the remote button to confirm the door operates correctly.
Programming a New Remote to a Gate via Original Remote 1. Stand within 1-2 meters of your gate’s control panel. 2. Press the button on the existing remote to open or close the gate. 3. As the gate begins to move, insert a pin into the center programming hole on the original remote (center of the 4 buttons). Hold it until the LED lights up for at least 2 seconds. 4. Remove the pin from the original remote. 5. On the new remote, press and hold the button you want to use for 2 seconds. 6. Release the button and wait for two seconds. 7. Press the same button again for another 2 seconds. 8. Wait 10-15 seconds and test the new remote.
Deleting All Remotes from the Motor 1. Disconnect the power to the motor at the power socket. 2. Hold down the Door Code or SW1 button on the motor. 3. While holding the button, reconnect power to the motor. The LED will light up after a few seconds, indicating the memory is cleared. 4. Release the button and test the remote. It should no longer operate the door.
IMPORTANT IMPORTANT: If the remote didn’t program, some models may have a full memory which prevents adding new remotes. You will need to delete all existing remote codes as explained in the instructions, then reprogram each remote (old and new) one by one.
Documents / Resources
 |
Garageway PTX5 v1 TrioCode Remote [pdf] Owner's Manual PTX-5v1, PTX5 v1 TrioCode Remote, PTX5, v1 TrioCode Remote, TrioCode Remote, Remote |