FG Helmet Bluetooth Intercom Kit

Product Information

Specifications:

  • Compliance: Part 15 of FCC Rules
  • RF Exposure: Meets general RF exposure requirement
  • Usage: Portable exposure condition without restriction

Product Usage Instructions

1. FCC Compliance

This device complies with Part 15 of the FCC Rules. Ensure that
the device is used in accordance with these regulations to prevent
harmful interference.

2. Operation Conditions

Operation of this device is subject to the following
conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including
    interference that may cause undesired operation.

3. Modifications

Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment. Avoid making unauthorized
modifications to the device.

4. RF Exposure

The device has been evaluated to meet general RF exposure
requirements. It can be used in portable exposure conditions
without any restrictions. Follow recommended guidelines for safe
exposure.

Frequently Asked Questions (FAQ)

Q: Can I make modifications to the device?

A: No, any changes or modifications not approved by the
responsible party may void the user’s authority to operate the
equipment.

Q: What are the operation conditions for this device?

A: The device must not cause harmful interference and must
accept any received interference to ensure proper operation.

“`

FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Documents / Resources

FreedConn FG Helmet Bluetooth Intercom Kit [pdf] User Manual
2ACB3-FG, 2ACB3FG, BL06.0050.0660, FG Helmet Bluetooth Intercom Kit, FG, Helmet Bluetooth Intercom Kit, Bluetooth Intercom Kit, Intercom Kit, Kit

References

Leave a comment

Your email address will not be published. Required fields are marked *