FOL PRO FS-R213 Portable Wireless Speaker System
Specifications
- Speaker Size: 4″+2.25 “x2
- Frequency Response: 50Hz – 20KHz
- SIN Ratio:278dB
- Output Power: 30W+10Wx2
- Power: 5V – 2A
- Battery Capacity:7.4V-4000mAh
Accessories
- Audio cable
- Charging line
- Instruction manual
Functional panel diagram
- M: Press this button to directly enter Bluetooth mode, then press to enter IJSB-FM Line mode, and then press to return to Bluetooth mode. Inserting a USB flash drive will be a priority in any mode.
- ” -“: Short press the previous song, in FM mode, short press this button to point to the previous channel.
Pressing them within a few seconds will lower the volume.
Long press to turn on, long press again to turn off. When the speaker is in a dead state, press and hold the power button for 8 seconds to restore the speaker to its initial state.- Short-press to enter Bluetooth mode and start connecting to the phone. After a successful connection, the Bluetooth indicator light remains on. Press 1-2 seconds to start TWS pairing connection. After a successful connection, the Bluetooth indicator lights on both speakers remain on. Double click to disconnect the Bluetooth connection of the phone once, and double click to disconnect the TWS connection twice.
- “+”: Short press the next song, and in FM mode, use this button to short press the next channel; Press for a few seconds, and it will turn up the volume.
: Short press to continue/stop. In FM mode, short press to mute, long press to automatically search for channels. During channel search, if short short-press is made, it will stop searching.- Battery indicator light
- Audio cable insertion port
- USB: USB input
- Charging Port Type-C, 5V-2A
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, punderpart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment geusesates, uses and radiates radio frequency energy and, if not installed and usbyith the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0 cm between the radiator and your body.
FAQs
Q: What should I do if the speaker is not connecting via Bluetooth?
A: Make sure the speaker is in Bluetooth mode and within range of the device you are trying to connect to. Also, check if the Bluetooth function on your device is turned on.
Q: How can I charge the speaker?
A: Use the provided charging line to connect the speaker to a power source. Ensure that the power source provides a voltage of 5V and a current of at least 2A.
Documents / Resources
 |
FOL PRO FS-R213 Portable Wireless Speaker System [pdf] Instruction Manual FS-R213LS, FS-R213 Portable Wireless Speaker System, FS-R213, Portable Wireless Speaker System, Wireless Speaker System, Speaker System, System |