Vacon 20 X – Simple operator panel
vacon 1

VACON 20 X – SIMPLE OPERATOR PANEL

1.1 Mounting instructions
Document code: DPD01577A
1.1.1 QDSH Simple operator panel kit

Table 1. Simple operator panel kit content.

1.1.2 Installation

1. • Remove the cover from the drive. See the Figure 2.
2. • Open only the inlet holes where you need to run the cables. Cables pass through this inlet hole.
3. • Connect the supply cable to the Mains switch passing through the cable gland from the bottom side (use the cable gland for sealing the cable to the drive) and then through the terminal box as shown in the figure below.
4. • Place the Simple Operator panel assembly with the cables inside the drive and fix it with its screws.
5. • Connect the cables from the Mains switch to the line terminals. The cables have to be connected to the terminals L1, L2 and L3.
6. • Fix the cables with the cable clamp.
7. • Connect the GROUND wire to the proper terminal (see the yellow-green cable on Figure 3.
8. • Connect the cables from the potentiometer and from the selector to the I/O control terminals. The cables have to be connected to the I/O terminals as shown in the Figure 3 and in the Table 2.
9. • RED, BLUE and BLACK wires are signals from the potentiomenter.
10. • YELLOW, WHITE and GREY wires are signal from the selector switch.
    Table 2. Control I/O terminal signal connections to the simple operator panel.

    Standard I/O terminals
    Terminal		Signal
    A	RS485_A	Serial bus, negative
    B	RS485_B	Serial bus, positive
    1	+10 Vref	Reference output
    2	AI1+	Analogue input, voltage or current
    3	GND	I/O signal ground
    6	24Vout	24V aux. voltage
    7	DIN COM	Digital inputs common
    8	DI1	Digital input 1
    9	DI2	Digital input 2
    10	DI3	Digital input 3
    4	AI2+	Analogue input, voltage or current
    5	GND	I/O signal ground
    13	DO1	Digital output 1 common
    14	DI4	Digital input 4
    15	DI5	Digital input 5
    16	DI6	Digital input 6
    18	AO1+	Analogue signal (+output)
    20	DO1+	Digital output 1

    Function	Description	Wire colors	Terminal
    Potentiomenter	10V reference output	RED wire	1
    	AI1+	BLUE wire	2
    	AI1-	BLACK wire	3
    Switch selector	24V auxiliary voltage	YELLOW wire	6
    	digital input DI1	WHITE wire	8
    	digital input DI2	GREY wire	9

11. • Mount the plastic cover onto the drive with its screws and the HMI cap: the installation process has been completed.

Service support: find your nearest Vacon service center at www.vacon.com

Documents / Resources

Factory Controls Vacon 20 X Simple Operator Panel [pdf] Instruction Manual Vacon 20 X Simple Operator Panel, Vacon 20 X, Simple Operator Panel, Operator Panel, Panel

References

• User Manual