EXIT TOYS MB320 GetSet Monkeybar
Product Information
The product is called GetSet MB320, also known as MGS-320-V01. It is a device that requires the following components for proper usage:
- Wood sheet (30x30cm)
- M12x45mm screws (8X)
- Concrete (25kg)
- Water
The device also requires a stable surface and the following IP addresses for connection:
- 61.80.30.20 (4X)
- 61.82.50.50 (2X)
- 61.85.50.60 (1X)
- 61.82.40.20 (2X) – NOT INCLUDED
Product Usage Instructions
- Prepare a stable surface to place the device.
- Place the wood sheet (30x30cm) on the surface.
- Secure the device using M12x45mm screws (8X).
- If available, connect the device to the IP addresses
provided:- 61.80.30.20 (4X)
- 61.82.50.50 (2X)
- 61.85.50.60 (1X)
- If not included, do not use the IP address 61.82.40.20.
- Mix concrete with water according to the instructions provided with the concrete bag.
- Pour concrete (25kg) onto the wood sheet.
- Allow the concrete to set and dry completely.
- Once the concrete is dry, the device can be used.
Note: The concrete used should be at least 3.5 cm thick for proper stability of the device.
EXIT TOYS MB320 GetSet Monkeybar
ASSEMBLY INSTRUCTIONS
Contact Information:
Dutch Toys Group B.V. Edisonstraot 83 7006 RB Doetinchem.
The Netherlands info@exittoys.com
Documents / Resources
 |
EXIT TOYS MB320 GetSet Monkeybar [pdf] Instruction Manual MGS-320-V01, MB320, MB320 GetSet Monkeybar, GetSet Monkeybar, Monkeybar |