Digilog 12V DC RGB LED Light Strip Driver IR Remote Controller

Digilog 12V DC RGB LED Light Strip Driver IR Remote Controller

Specifications

Working temperature: -20-60°C
Product size: L62xW35xH23mm
Net weight: 60g
Output: Three CMOS drain-open output
Max load current: 2 A each color
Supply voltage: DC12V
Package size: L105xW65xH55mm
Gross weight: 90g
Connecting Mode: Common anode

Control Method

Adopt IR remoter to control the led controller, which has 44 buttons, the function of each button as the table below.

Brightness riseBrightness fallPause/RunOn/Off
Static redStatic greenStatic blueStatic white
Static orangeStatic light greenStatic dark blueStatic milk white
Static dark yellowStatic dyanStatic Ions blueStatic white pink
Static yellowStatic light blueStatic purpleStatic green-white
Static light yellowStatic sky blueStatic brownStatic blue white
Increase redIncrease greenIncrease blueSpeed up
Decrease redDecrease greenDecrease blueSpeed-down
DIY key1DIY key2DIY key3Automatic change
DIY key4DIY key5DIY key6Flash on and off
3 color jumpy change7 color jumpy change3 color fade change7 color fade change

About DIY key, when it’s pressed first time, will enter the DIY color mode, you can adjust the color per the 6 keys at above to increase or decrease the R/G/B color by yourself freely (if other key is pressed this time, will jump out from DIY color mode). And you can save the color which you have adjusted by pressing the DIY key once again. When next time this key is pressed, it will show the color you saved last time.
There are 6 DIY keys, so you can save 6 color you like. They are all Independent, have no effect each other.
For example: if you press DIY key1 first, and then press DIY key2, DIY key1 will be invalid, until DIY key2 is pressed once again, current color will be saved.

Panel Specification And Connecting Drawing As Follows

Panel Specification And Connecting Drawing As Follows

Warning

  1. Supply voltage of this product is DC12V never connect to DC24V or AC220V.
  2. Never connect two wires directly in case of short circuit.
  3. Lead wire should be connected correctly according to colors that connecting diagram offers.
  4. Warranty of this product is one year, in this period we guarantee replacement or repairing with no charge, but exclude the artificial situation of damaged or overload working.

Documents / Resources

Digilog 12V DC RGB LED Light Strip Driver IR Remote Controller [pdf] Instruction Manual
12V DC RGB LED Light Strip Driver IR Remote Controller, LED Light Strip Driver IR Remote Controller, Light Strip Driver IR Remote Controller, Strip Driver IR Remote Controller, Driver IR Remote Controller, IR Remote Controller, Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *