Data-Signs-logo

Data Signs Portable Traffic Light Controller NxG

Data-Signs-Portable-Traffic-Light-Controller-NxG-product

Product Specifications

  • Product Name: Portable Traffic Light
  • Usage: Onsite traffic management
  • Operation: Requires qualified traffic managers
  • RF Channels: 1-8
  • Modes: Demand, Auto (Timed), Manual

Information

CAUTION: THE DATA SIGN PORTABLE TRAFFIC LIGHTS SHOULD ONLY BE OPERATED BY QUALIFIED TRAFFIC MANAGERS. IF YOU HAVE HIRED OUT THIS PTL, CONTACT THE HIRE COMPANY FOR ASSISTANCE.

CHECK: CAN YOU SEE THE OTHER LIGHT?
LINE OF SIGHT IS REQUIRED.

BOTH LIGHTS MUST BE SET, USUALLY DO THE SUB PTL FIRST.

Using Instructions

  • Press and holdData-Signs-Portable-Traffic-Light-Controller-NxG-fig-1 to switch ON. Then pressData-Signs-Portable-Traffic-Light-Controller-NxG-fig-2
  • From the Main Menu, select QUICK START and pressData-Signs-Portable-Traffic-Light-Controller-NxG-fig-3

Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-4

The Quick Start menu item is used to get your PTL Lights set up in a few simple steps:

  1. To set up each PTL, selectData-Signs-Portable-Traffic-Light-Controller-NxG-fig-5 for Sub orData-Signs-Portable-Traffic-Light-Controller-NxG-fig-6 for MAIN controller and pressData-Signs-Portable-Traffic-Light-Controller-NxG-fig-3
  2. Select the RF Channel (1-8) or press Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-3to keep current channel.
  3. Select * YES = OPERATIONData-Signs-Portable-Traffic-Light-Controller-NxG-fig-3
  4. Enter the ROAD LENGTH.
    • If you are setting the MAIN PTL, set the ROAD SPEED and GREEN TIME also.
  5. Finally, select Shuttle Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-7or Plant Crossing Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-8operation.

MODES

The current MODE setting is shown on the top display line in between the square brackets. i.e. [AUTO] as per above display screen.

  • DEMAND is Vehicle-actuated Mode. Vehicle detectors MUST be fitted.
  • AUTO (TIMED) is Automatic Timed Mode.
  • MANUAL is Manual Mode (using the and buttons or the PTL REMOTE).

Note: If Lights are not operating as expected, from the MAIN MENU, select FACTORY RESET Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-9andData-Signs-Portable-Traffic-Light-Controller-NxG-fig-10 then do the QUICK START again (this will reset all setting back to the default settings).

FAQ

Frequently Asked Questions

  • Q: Can anyone operate the Portable Traffic Light?
    • A: No, only qualified traffic managers should operate the Portable Traffic Light.
  • Q: What should I do if the lights are not operating correctly?
    • A: Perform a FACTORY RESET from the MAIN MENU and redo the QUICK START setup to reset settings.

More Information

Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-12Video demonstrations

Scan the QR code and select the appropriate video to watch.

Data-Signs-Portable-Traffic-Light-Controller-NxG-fig-11

Documents / Resources

Data Signs Portable Traffic Light Controller NxG [pdf] User Guide
PTL-Quick-Start-Guide, Portable Traffic Light Controller NxG, Portable Traffic Light, PTL Controller NxG, PTL Controller, NxG

References

Leave a comment

Your email address will not be published. Required fields are marked *