Danfoss 088U1110 Icon Floor Sensor User Manual
Instruction
Use conduit systems for electrical installations acc. to EN/IEC 61386-23
The floor sensor must be mounted in a insulating conduit, sealed at the floor end (1), for easy replacement of the floor sensor if necessary.
The minimum bending radius is 5 cm (2).
The best placement for the floor sensor, is centered between two floor heating loops (3).
The floor sensor is a LIVE cable; therefore any extension made to the sensor wiring should be treated in the same way as normal main voltage cabling.
Type: NTC 47 kΩ / 25˚C, 3 m
13690 000 01 Manual Installation SC 3 Metre Danfoss / VISUK20F
Documents / Resources
 |
Danfoss 088U1110 Icon Floor Sensor [pdf] User Manual 088U1110 Icon Floor Sensor, 088U1110, Icon Floor Sensor, Floor Sensor, Sensor |
