Cisco Collaboration Device
Safety Information
78-101123-05C0 © 2023 Cisco Systems, Inc.
All rights reserved.
Where to Find Product Documentation
Product Information
https://help.webex.com
https://www.cisco.com/go/telepresence/docs
Warranty Information
https://www.cisco.com/go/warranty
Regulatory, Compliance, and Safety Information
https://www.cisco.com/go/telepresence/docs
End User License Agreement and License Information
https://www.cisco.com/go/eula
https://www.cisco.com/go/license
Antennas
The device has integrated antennas which cannot be replaced.
Radio Channels
The phones use World Mode (802.11d) to
determine operating channels and transmit powers.
Intended Use
This product is a collaboration endpoint for use primarily in an office environment.
For indoor use only.
Installation
Minimum separation distance: 20 cm / 7.9 in
Safety Instructions – Warnings
Read the installation instructions before using, installing or connecting the system to the power source.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Ultimate disposal of this product should be handled according to all national laws and regulations.
No user-serviceable parts inside. To avoid risk of electric shock, do not open. Installation of the equipment must comply with local and national electrical codes.
National Restrictions
This section identifies countries that have additional requirements or restrictions.
For FCC (US)
Modification Statement (§15.21):
Changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Compliance Statement (§15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Class A Interference Statement (§15.105a): This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
For IC (Canada)
Interference Statement
(RSS-GEN, Section 8.4):
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 5150-5250 MHz is limited to use indoor only. The use of 5600-5650 MHz is restricted.
Exposure statement (§2.1091)
(US, Canada)
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
EU Directive 2014/53/EU – Compliance Information for the Cisco Collaboration series Wireless LAN products.
Scope
The information in this document is applicable to the Cisco Collaboration series wireless LAN products that currently includes the DX series, Room series and Cisco Spark Board. These products are intended to be placed on the market within the European Union, Lichtenstein, Switzerland, Iceland, Norway, Turkey and other countries that have implemented the EU Directive 2014/53/EU.
Simplified EU Declaration of Conformity
This declaration is only valid for configurations (combinations of software, firmware and hardware) provided and/or supported by Cisco Systems for use within the EU or countries that have implemented the EU Directives and/ or spectrum regulation.
The use of software or firmware not supported/provided by Cisco Systems may result that the equipment is no longer compliant with the regulatory requirements.
This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/ЕU.
Note: The full declaration of conformity for these products can be found:
- Cisco Room Kit: https://www.cisco.com/web/dofc/11580633.pdf
- Cisco Room Kit Mini: https://www.cisco.com/web/dofc/15708585.pdf
- Cisco Codec Plus: https://www.cisco.com/web/dofc/11580590.pdf
- Cisco Codec Pro: https://www.cisco.com/web/dofc/13510636.pdf
- Cisco Codec EQ (TTC6-15): https://www.cisco.com/web/dofc/EU90135.pdf
- Cisco Room 55: https://www.cisco.com/web/dofc/11676060.pdf
- Cisco Room 55 Dual: https://www.cisco.com/web/dofc/14982501.pdf
- Cisco Room 70: https://www.cisco.com/web/dofc/11889510.pdf
- Cisco Room 70 G2: https://www.cisco.com/web/dofc/15041520.pdf
- Cisco Room 70 Panorama: https://www.cisco.com/web/dofc/15041520.pdf
- Cisco Room Panorama: https://www.cisco.com/web/dofc/13510636.pdf
https://www.cisco.com/web/dofc/EU82940.pdf - Cisco Board 55: https://www.cisco.com/web/dofc/11530677.pdf
- Cisco Board 55S: https://www.cisco.com/web/dofc/15570334.pdf
- Cisco Board 70: https://www.cisco.com/web/dofc/11653359.pdf
- Cisco Board 70S: https://www.cisco.com/web/dofc/15570336.pdf
- Cisco Board 85S: https://www.cisco.com/web/dofc/15612170.pdf
- Cisco Desk Pro: https://www.cisco.com/web/dofc/18745436.pdf
- Cisco Room Bar: https://www.cisco.com/web/dofc/22921945.pdf
Contains FCC ID: LDK073002357
Contains IC ID: 2461N-073002357 - Cisco Room Bar Pro (TTC4-01): https://www.cisco.com/web/dofc/EU92051.pdf
- Cisco Board Pro 55: https://www.cisco.com/web/dofc/22241423.pdf
WiFi/BT, contains FCC ID: LDKNVTX21737 and contains IC ID: 2461N-NVTX21737 24 GHz (radar), FCC ID: LDK603102338 and
IC ID: 2461N-603102338 - Cisco Board Pro 75: https://www.cisco.com/web/dofc/22540558.pdf
WiFi/BT, contains FCC ID: LDKNVTX21737 and contains IC ID: 2461N-NVTX21737 24 GHz (radar), FCC ID: LDK603202337 and IC ID: 2461N-603202337
Cisco.com login is required to access these documents. You can register for a Cisco.com account if you don’t have one.
EMC Class A declaration
WARNING: This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Art. 5th – Resolution Nº 680/2017 (Brazil)
This equipment is not entitled to the protection from harmful interference and may not cause interference with duly authorized systems.
Cisco and the Cisco logo are trademarks or registered On our web site you will find an overview of the worldwide Cisco contacts. Go to: https://www.cisco.com/web/siteassets/contacts
Notice: Please Read for Important Information
About Your Device
Corporate Headquarters
Cisco Systems, Inc.
170 West Tasman Dr.
San Jose, CA 95134 USA
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Thirdparty trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship
between Cisco and any other company. (1110R) nd User License Agreement (EULA) go ing software. http://www.cisco.com/go/eula
Documents / Resources
 |
CISCO 0401B2757 Collaboration Device [pdf] User Manual 0401B2757 Collaboration Device, 0401B2757, Collaboration Device, Device |
