How to Replace the Drum Unit

Replacing Drum Unit

RESET THE DRUM UNIT COUNTER by using the control panel.

RESET THE DRUM UNIT COUNTE

Make sure the machine is turned on.

• LED Models
  (1) Make sure that the front cover is open.
  (2)Press and hold Go for about four seconds until all of the LEDs light up. When all four LEDs are lit, release Go.
  (3)Close the front cover.
  (4)Make sure the Drum LED is now off.
• 1-line LCD Models
  (1) Close the front cover.
  (2)Press OK and A at the same time.
  (3)Press OK to select Drum.
  (4)Press V to reset the drum counter.
• 2-line LCD Models
  (1)Close the front cover.
  (2)Press OK and A at the same time.
  (3)Press OK to select Drum.
  (4) Press A to reset the drum counter.
• Touchscreen Models
  (1)Close the front cover.
  (2)Press X
  (3) Press and hold for five seconds.
  (4)Press Drum, and then press Yes.

Visit www.brother.com/oriqinal for instructions on how to return your used supplies to the Brother collection program. If you choose not to return used supplies, please discard them according to local regulations, keeping them separate from domestic waste. If you have questions, call your local waste disposal office.

In USA, go to www.hrother-usa.com/Envirnnment/InnerInkDisnnsal.asoK
In Canada, go to www.brother.ca/en-CA/environment/cartridgecollectinnprogram.

Documents / Resources

brother Replacing Drum Unit [pdf] Instructions Replacing Drum Unit, Replacing Drum, Drum Unit

References

• User Manual