Blxecky A19 Smart Bulb

1.  Connect your phone to WiFi(Only 2.4Ghz)
2.  Turn on the phone’s Bluetooth

Adjust the bulb to blink

Turn on/off 3 times(on/off/on/off/on)

FAQ&Feedback

1. 0nly support 2.4GHz, not 5GHz.
2.  The distance between the device and the router should not be too far away, which will affect the Wi-Fi signal.
3. Make sure the Wi-Fi password is entered correctly,just English and Numbers.
4.  lf the connection fails, please set the router safety factor to the lowest.
5.  lf the connection fails, try sharing the access point with another phone instead of the router’s Wi-Fi. This method can help us determine if the Wi-Fi signal from the router is compatible with this product.
6.  When the device is connected correctly, don’t remove it; otherwise, it will be restored to factory settings and cannot be controlled directly.
7.  lf the device is offline and can’t be controlled, check if the Wi-Fi is off, turn off some other connected devices, the router may be overloaded, update the application interface.
8. If you change the Wi-Fi password, please reconnect. When restoring factory settings, you must turn off the lamp for 10 seconds and then try again.

12-month quality guarantee
Connection failure or other problems are often caused by poor compatibility between the router and the mobile phone,please contact us, we have professional technicians to help you solve it,after we help you solve the problem, please give us a positive evaluation, we need your affirmation and encouragement, Thank you.

Documents / Resources

Blxecky A19 Smart Bulb [pdf] User Manual A19 Smart Bulb, A19, Smart Bulb

References

• User Manual