AZZA NEPTUNE Computer Case

Specifications

Chassis Parts

Control Panel Functions

3.5 “/ 2.5” HDD/SSD Installation

Graphics Card Specifications

Remove the left glass side panel

Cooling System Installation

Side

Rear

Top

3x120mm fan ports on the mb side

Fan Installation

RGB Lighting Switching

 

Fan Installation

• Before the fan starts, please make sure the SATA connector 5 is connected.
• Press the LED button to cycle through different RGB lighting modes, all ARGB devices are controlled by the LED button. (make sure the other 3pin ARGB device is connected with 3)
• Ensure 2 insert the motherboard and hold the LED button for 3 seconds to switch the RGB control function to the motherboard RGB sync. software. Press the LED button for 1 second, to switch the RGB control function to the LED button.

Documents / Resources

AZZA NEPTUNE Computer Case [pdf] User Manual NEPTUNE Computer Case, NEPTUNE, Computer Case, NEPTUNE Case

References

• User Manual