AzureWave AW-HM610 802.11ah Module EVK
Revision History
Document NO:
| Version | Revision Date | DCN NO. | Description | Initials | Approved |
| 0.1 | 2023/11/30 | Initial Version | Daniel
Lee |
NC Chen | |
Overview
Device supported
This document supports the AW-HM610 (12 x 12 mm LGA Module). The AW-HM610 test board can be operated in MFG mode or Host Mode. If you want to perform the AW-HM610 RF performance test, please contact the relevant personnel of Newracom to obtain the NRC7394 Manufacturing Test Tool GUI (MFT GUI) and related user guides.
Basic Setup and Requirements for MFG Mode
This section provides detailed information about the setting for the AW-HM610 demo board. Shows the overview of the AW-HM610 test board physical photo and PCB placement (TOP). The description of the jumpers’ functions and settings on the demo board is as follows:
Azurewave AW-HM610 test board physical photo and PCB placement
Operation Mode Configurations
AW-HM610 can be operated in MFG mode or Host Mode through the setting of jumper
Power Supply
- The 5.0V power supply can be provided by a USB connector (CON101) and a short J10.
- The 3.3V power supply (J3) for AW-HM610 pin.9 VBAT is converted from the 5V power supply through the LDO on the demo board. You can measure the current of VBAT by connecting an ammeter in series with J3.
- The 1.8V power supply is converted from the 3.3V power supply through the LDO on the demo board. You can measure the current of VDDIO by connecting an ammeter in series with J2.
- VDDIO for AW-HM610 can be set to 1.8V or 3.3V through J8
- Short J8 pin.2 and pin.1 to set VDDIO to 3.3V (default)
- Short J8 pin.2 and pin.3 to set VDDIO to 1.8V
USB to UART (J12 & J13)
Set the UART port (UART0) of AW-HM610 by short-circuiting J12 and J13.
GPIOs and JTAG (J6)
The GPIO pins of AW-HM610 are connected to J6, the definition of each pin is as follows.s
Basic Setup and Requirements for Host Mode
AW-HM610 can be connected to the Host side via an SPI interface. The picture below is a photo of the AW-HM610 demo board connected to Raspberry Pi4 via J11-B. Please note that the mode of J4 must be set correctly when operating in Host Mode.
J4 = L (Host Mode)
- FORM NO.: FR2-015_ A
- Responsible Department：W BU
- Expiry Date: Forever The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of AzureWave.
Documents / Resources
 |
AzureWave AW-HM610 802.11ah Module EVK [pdf] User Guide AW-HM610 802.11ah Module EVK, AW-HM610, 802.11ah Module EVK, Module EVK, EVK |