Aula F98 Swappable RGB Gasket Mechanical Keyboard User Manual

Product Overview

Connection instructions

1. Switch to [ON]
2. Remove the [USB
3. Receiver] from the upper right corner slot of the keyboard port to use.

~ key cyan light slow flashing, then long press FN + ~ key cyan light fast flashing into the code state, then insert the receiver to complete the code, ~ key cyan light 2s, 2.4G link successfully.
Note: 2.4G connection first search before inserting the receiver. The factory default has been coded.

BT Connection Instructions

1. Switch to [ON]
2. Long press the key combination”FN+ 1″ for about 5 seconds the “1” key starts fast and flashes blue light, into the code pairing
3. Search for the pairingname[AULA-F98], the Bluelight will turn on for 2 seconds after the connection is successful state.

Note

• B2 and BT are connected in the same way as BT1, BT2 can be connected by pressing the combination key [FN+2@].
• BT 3 can be connected by pressing the combination key [FN+3#]: The blue light blinks slowly when BT is connected again.

Wired Mode

1. Switch to [ON]
2. Plug the Type-C cable into the port on the keyboard
3. Plug another USB into your computer’s USB port

Download PDF: Aula F98 Swappable RGB Gasket Mechanical Keyboard User Manual

References

• User Manual