Atulo Products TABP-101 Digital Projector Clock
Intended Use
The Digital projector clock™ is intended for individuals using compatible CGMs who want a convenient and effortless way to monitor. It enables real-time, at-a-glance updates without needing to reach for a phone or reader.
Package Contents
- Digital projector clock™ Device
- USB-C Cable
- User Manual
- Backup Coin Cell Battery (for clock memory)
Setup Instructions
Power On
Connect the included USB-C cable to the device and plug it into a USB-compatible power adapter.
Positioning
Place the Digital Projector Clock™ on a bedside table. Adjust the projector to display on your ceiling or wall.
Pairing with CGM
Make sure your CGM app is open and connected to the internet.
To pair
- Press the Setup Reset button on the back of the Digital Projector Clock™.
- A blinking star on the screen indicates that the device is in pairing mode.
- On your mobile device, go to: Settings → Wi-Fi → Glucose Clock Config
- If prompted for a password, enter: 12345678
- Once connected, the Digital Projector Clock Settings screen will appear.
- Fill in the required fields and press Save Settings.
- The device will beep to confirm that the settings were saved successfully.
Light/Stop Button (Top of the Device)
- Adjusts screen brightness
- Snoozes the alarm
Warnings and Safety Information
Proposition 65 Warning
This product contains a lithium-ion battery, which is known to the State of California to cause cancer and birth defects, or other reproductive harm.
For more info: www.P65Warnings.ca.gov
Coin Cell Battery Warning
- Keep out of reach of children
- Swallowing may cause serious injury or death
- If swallowed, seek emergency medical attention immediately
- Dispose of batteries according to local regulations
Maintenance & Cleaning
- Use a soft, dry cloth to clean the exterior
- Do not use harsh chemicals or abrasive materials
- Keep the projector lens clean and dust-free
Storage
Store the Digital projector clock™ in a cool, dry location away from direct sunlight and heat.
FCC compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with the FCC’s RF Exposure guidelines. This equipment should beinstalled and operated with a minimum distance between 20cm and the radiator of your body: Use only the supplied antenna.
Documents / Resources
 |
Atulo Products TABP-101 Digital Projector Clock [pdf] User Manual TABP-101, 2BDJMTABP-101, 2BDJMTABP101, TABP-101 Digital Projector Clock, TABP-101, Digital Projector Clock, Projector Clock, Clock |