ATOMSTACK F3 Honeycomb Laser Bed
Product Information
The F3 honeycomb laser bed is a component of the product. It is designed to be used with M4*10 and M4*14 screws. The bed has an L-shaped structure and comes with various numbered parts.
Product Usage Instructions
- Start by assembling the F3 honeycomb laser bed using the provided screws. Use the M4*10 screws to secure the parts marked with “L” and “01”. Use the M4*14 screws for the parts marked with “R” and “02”.
- Continue assembling by using the M4*10 screws for the parts marked with “L”, “L”, “M4*10”, and “M4*10”. Use the M4*14 screws for the parts marked with “R”, “R”, “1”, “2”, “3”, and “4”.
- Proceed to assemble the remaining parts using the specified screws. Use the M4*14 screws for the parts marked with “M4*14”, “M4*14”, “5”, and “03”. Use the M4*10 screws for the part marked with “6”.
- To prevent smoke from blackening the desktop during cutting, it is recommended to place a paper pad under the cutting protective panel.
- For detailed warranty policy, please visit our official website at: www.atomstack.com. For technical support and service, please email: support@atomstack.com.
What’s In The Box
Installation
It is recommended to pad paper under the cutting protective pannel to prevent smoke from blackening the desktop.
Warranty
- For detailed warranty policy,please visit our official website at: www.atomstack.com.
- For technical support and service,please email: support@atomstack.com.
Documents / Resources
 |
ATOMSTACK F3 Honeycomb Laser Bed [pdf] Instruction Manual F3 Honeycomb Laser Bed, F3, Honeycomb Laser Bed, Laser Bed, Bed |