APEX MEDICAL CORP.
XT Auto
Notice! Please remove the guide before giving the device to the patient. Only medical professionals could adjust pressure settings.
Provider Setup Navigation
- Press “Menu”
to any 
Menu (See Operation Flow on the right) while in the Standby screen. - Hold down both the “UP”
& ”Down” 
buttons, and then simultaneously press the “Menu” for 1 second. When the screen starts blinking, the Provider Mode would be unlocked. - Press “UP” and ”Down” to adjust the settings.
- Press “Menu” to confirm the settings.
- Press the “Start/Standby”
to go back to the standby screen.
Provider Mode Quick Guide
Re-set the Compliance Meter
- In the standby screen, press “Menu” to select [CM xxxx.x hr] menu.
- Accessing the Provider Mode first (Press
), then the screen starts blinking. - Press “UP” or ”Down” , then the screen will show [Clear].
- Press “Menu” to confirm the settings, and the Compliance Meter record will be erased. The screen will show [Clear OK] when finishing the process.
Engineering Mode Quick Guide
Accessing the Engineering Mode
1. Plug the power supply into the iCH device.
2. Before it shows [Standby] screen, hold down both the “Starts/Standby” and “Menu” buttons for 1 second, the
Engineering Mode would be unlocked.
Re-set the Total Meter
- Accessing the Engineering Mode first, then the screen will show [TM xxxx.x hr] menu.
- Hold down both the “UP” & ”Down” buttons, and simultaneously press the “Menu” , and then the screen starts blinking.
- Press “UP” or ”Down” , then the screen will show [Clear].
- Press “Menu” to confirm the settings, and the screen will show [TM CLr Clear],and the Total Meter record will be erased.
- The screen will show [TM End Clear OK] when finishing the process.
Care for a Healthy Life.
Documents / Resources
 |
APEX XT Auto Automatic Positive Airway Pressure [pdf] User Guide XT Auto, Automatic Positive Airway Pressure |
