ANALOG DEVICES logoPRECISION HIGH VOLTAGE
High Voltage Drive
Rev. 0 | Mar. 2022
USER GUIDEANALOG DEVICES PRECISION High Voltage High Voltage -

PRECISION High Voltage High Voltage Drive

POWER SOLUTIONS FOR PRECISION TECHNOLOGY SIGNAL CHAINS
This document is interactive. You can click on any underlined text to navigate through the document.

For the resources:

ANALOG DEVICES PRECISION High Voltage High Voltage - For the resources

For the individual pages:

ANALOG DEVICES PRECISION High Voltage High Voltage - For the individual pages

Precision High Voltage
High Voltage Drive

APPENDIX Parts Guide
Power Requirements

Non-isolated; Multichannel
With ADHV4702-1 Driver

ANALOG DEVICES PRECISION High Voltage High Voltage - 1

With LTC6090 Driver

ANALOG DEVICES PRECISION High Voltage High Voltage - 2

With LTC6091 Driver

ANALOG DEVICES PRECISION High Voltage High Voltage - 3

PART # DESCRIPTION
LT8304-1 100VIN Micropower No-Opto Isolated Flyback Converter with 150V/2A Switch
LT3471 Dual 1.3A, 1.2MHz Boost/Inverter in 3mm ×3mm DFN
LT8570 Boost/SEPIC/Inverting DC/DC Converter with 65V Switch, Soft-Start and Sync.
LT8604 High Efficiency 42V/120mA Synchronous Buck
ADP7118 20V, 200mA, Low Noise, CMOS LDO Linear Regulator
ADP7182 –28V, −200mA, Low Noise, Linear Regulator

POWER REQUIREMENTS

PARAMETER STAGES PMU DAC & ADC Driver
Part # Pin AD5522 [1] ADHV4702-1
[2] LTC6090
[3] LTC6091
AVDD AVSS DVCC VCC/V+ VEE/V-
Supply Voltage V 15 -15 5 [1] 110
[2] 70
[3] 70
-250
Supply Current mA 36 -36 1.5 [1] 3.3
[2] 4.3
[3] 4.3 (per amp)
-3.3
-4.3
-4.3 (per amp)
PSRR dB 45 (100kHz) 50 (100kHz) 80 (100kHz) [1] 35 (100kHz)
[2] 80 (100kHz)
[3] 75 (100kHz)
83 (100kHz)
40 (100kHz)
40 (100kHz)

Note 1: The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components.
Note 2: The supply voltages indicated are the values for typical applications.
Note 3: Consult the corresponding datasheets for details on power dissipation if needed.
Note 4: The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.

©2022 Analog Devices, Inc. All rights reserved.
Trademarks and registered trademarks are the property of their respective owners.

Documents / Resources

ANALOG DEVICES PRECISION High Voltage High Voltage Drive [pdf] Instructions
PRECISION High Voltage High Voltage Drive, PRECISION High Voltage, Voltage Drive, High Voltage Drive, PRECISION Drive

References

Leave a comment

Your email address will not be published. Required fields are marked *