ANALOG DEVICES LT3471 Adaptable Voltage Drive Noise and Stability Optimized
PRECISION SIGNAL CHAIN
This document is interactive. You can click on any underlined text to navigate through the document.
For the resources

For the individual pages:
APPENDIX 1-Channel
PART
PART # | DESCRIPTION |
LT3471 | Dual 1.3A, 1.2MHz Boost/Inverter in 3mm × 3mm DFN |
LT8604 | High Efficiency 42V/120mA Synchronous Buck |
LT8570 | Boost/SEPIC/Inverting DC/DC Converter with 65V Switch, Soft-Start and Sync. |
LT3999 | Low Noise, 1A, 1MHz Push-Pull DC/DC Driver with Duty Cycle Control |
ADP7118 | 20V, 200mA, Low Noise, CMOS LDO Linear Regulator |
ADP7142 | 40V, 200 mA, Low Noise, CMOS LDO Linear Regulator |
ADP7182 | –28V, −200mA, Low Noise, Linear Regulator |
POWER REQUIREMENTS
PARAMETER |
STAGES | Buffer | Buffer | Isolation | DAC | Amp | Protection | ||||||||
Part # | ADA4077 | AD8676 | ADuM1441 | AD5791 | AD8675 | ADG5401F | |||||||||
Pin | V+ | V- | V+ | V- | VDD1 | VDD2 | VCC | IOVCC | VDD | VSS | V+ | V- | VDD | VSS | |
Supply
Voltage |
V |
15 |
-15 |
15 |
-15 |
3.3 |
3.3 |
3.3 |
3.3 |
15 |
-15 |
15 |
-15 |
15 |
-15 |
Supply Current | mA |
0.65 |
-0.65 |
4.2 |
-4.2 |
0.9 |
-0.75 |
0.9 |
0.14 |
5.2 |
-4.9 |
3.8 |
-3.8 |
0.22 |
0.09 |
PSRR | dB | 12
(1MHz) |
24
(1MHz) |
22
(1MHz) |
68
(1MHz) |
– | – | 48
(1MHz) |
52
(1MHz) |
82 (1MHz) |
- Note 1: The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components.
- Note 2: The supply voltages indicated are the values for typical applications.
- Note 3: Consult the corresponding datasheets for details on power dissipation if needed.
- Note 4: The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.
Documents / Resources
![]() |
ANALOG DEVICES LT3471 Adaptable Voltage Drive Noise and Stability Optimized [pdf] User Guide LT3471 Adaptable Voltage Drive Noise and Stability Optimized, LT3471, Adaptable Voltage Drive Noise and Stability Optimized |