ALL LED AIQ-4Z-RMT Mono 4 Zone Smart Remote Control
Product Specifications
- Product Code: AiQ/4Z/RMT
- Protocol: ZigBee 3.0
- Operating Voltage: 3VDC
- Battery Type: CR2032 x1
- Transmission Frequency: 2.4 GHz
- Transmission Range (Uninterrupted): 30 m
- Ingress Protection: IP20
Product Usage Instructions
Quick Install Guide:
To use the remote with your Smart Home Hub and lighting devices, follow either Option 1 or Option 2. If using the remote directly with your lighting control devices without a Hub, follow Option 2.
- Option 1: Connecting Your Remote to a Smart Home Hub
- From your smart home hub interface, select to add a device and enter pairing mode.
- Press and hold down the All On button until the LED indicator turns on.
- Immediately press the All Off button. The LED indicator will flash. After 20 seconds, the remote will time out. A quick triple blink indicates successful pairing.
- Option 2: Connecting Your Remote to Intelligent Lighting Control Devices
- Set the receiving device to Find and Bind mode. The lights will flash to indicate active mode for 3 minutes.
- Bring the remote within 10 cm of the lighting device within the active duration.
- Short press the ON button of the desired group (1-4) to select a group for pairing.
- Press and hold down the All ON button until the LED indicator turns on.
- Immediately press group 1 ON button to start pairing. The LED indicator will flash fast for 3 seconds, then flash slowly six times to indicate successful pairing.
Factory Reset Remote:
If unsuccessful in pairing, factory reset the remote by pressing and holding down the All ON button until LED indicator turns on, then pressing All Off button.
FAQ
- What should I do if the LED indicator does not blink as expected during pairing?
If the LED indicator does not blink as expected during pairing, perform a factory reset of the remote and try again. - How many scenes can I save per group with this remote?
You can save up to 2 scenes per group using this remote. - What is the transmission range of this remote?
The uninterrupted transmission range of this remote is 30 meters.
PRODUCT OVERVIEW
SPECIFICATION
| Product Code | AiQ/4Z/RMT |
| Protocol | ZigBee 3.0 |
| Operating Voltage | 3VDC |
| Battery Type | CR2032 x1 |
| Transmission Frequency | 2.4 GHz |
| Transmission Range (Uninterrupted) | 30 m |
| Ingress Protection | IP20 |
Quick Install Guide
To be able to use a remote with your Smart Home Hub and intelligent lighting devices follow (Option 1 and Option 2). If you would like to use your remote directly with your intelligent lighting control devices without a Hub, follow instructions (Option 2).
Remove protective film on battery before first use.
Option 1: Connecting Your Remote to a Smart Home Hub e.g. Alexa Echo
Option 2) Connecting your remote to Intelligent lighting control devices.
Factory Reset Remote
Remove Paired Devices
Removing An Intelligent Lighting Control Device From Your Remote
Scenes
How To Save Scenes
How to Recall Saved Scenes
Step 1: Short press either the S1 or S2 buttons to recall a saved scene for each individual group.
Dimensions
Returns & Faulty Items
- If any problem is encountered during or after installation, please call the All LED technical department to get the problem resolved as soon as possible.
- Please do not just return the item to the outlet you purchased it from, as you are only entitled to a replacement or refund after the unit has undergone testing and the unit has been confirmed as having a manufacturing defect/fault. Your statutory rights are not affected.
- The manufacturer will not be deemed liable or held responsible for any damages caused by faults or manufacturing defects that may be present in any of its products or the misuse or incorrect installation of this device. Please refer to our troubleshooting guide for further information.
- All goods are supplied under the terms and conditions of All LED LTD, a copy of which may be obtained upon written request.
ABOUT COMPANY
- ALL LED LTD
- 42 Sedgwick Road,
- Luton, LU4 9DT
- www.allledgroup.com
- sales@allledgroup.com
- Tel: +44 (0)208 841 9000
Documents / Resources
 |
ALL LED AIQ-4Z-RMT Mono 4 Zone Smart Remote Control [pdf] Installation Guide AIQ-4Z-RMT, AIQ-4Z-RMT Mono 4 Zone Smart Remote Control, Mono 4 Zone Smart Remote Control, 4 Zone Smart Remote Control, Smart Remote Control, Remote Control, Control |
