AAMP P-BUA-TRANSIT CONNECT Wiring Harness for Backup Alarm 2014 to 2022 Ford Transit Connect

Thank you for purchasing the

P-BUA-TRANSIT CONNECT

WHAT’S INCLUDED:

• Vehicle Specific Wire Harness (P-BUA-TRANSIT CONNECT)

COMPATIBLE ACCESSORIES:

• 97dB Backup Alarm (BUA-97C)

TOOLS REQUIRED:

1. 10mm Nut-setter
2. Impact Drill
3. Panel Removal Tool
4. Fish Tape
5. Knife

Instructions for Use

• STEP 1: Locate and disconnect the OEM tail lamp connector that is in the driver side rear corner of the vehicle
  
• STEP 2: Install the P-BUA-TRANSIT CONNECT harness between the OEM connectors
  
• STEP 3: Route the harness down the driver side rear corner cavity.
  
• STEP 4: Remove the pictured grommet, so that the harness may pass through.
  Use a fish tape to route the 2 pin connector of the harness down through the bottom of the rear corner cavity and below the vehicle
  
• STEP 5: Use an impact drill and 10mm nut-setter to install a compatible backup alarm on the underside of the vehicle
  Note: (2) 10mm TEK screws are provided with the compatible backup alarm
  
• STEP 6: Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT CONNECT harness. Use a knife to make a small cut in the grommet before it is re-installed
  
• STEP 7: Test the backup alarm

Customer Service

Phone – 866-931-8021 (option 3)
E-Mail – support@aampglobal.com
AAMP Commercial is a Power Brand of AAMP Global
aampcommercial.com

Documents / Resources

AAMP P-BUA-TRANSIT CONNECT Wiring Harness for Backup Alarm 2014 to 2022 Ford Transit Connect [pdf] Instruction Manual P-BUA-TRANSIT CONNECT, Wiring Harness for Backup Alarm 2014 to 2022 Ford Transit Connect, P-BUA-TRANSIT CONNECT Wiring Harness for Backup Alarm 2014 to 2022 Ford Transit Connect

References

• User Manual