MW APC-16E series 16W Single Output Switching Power Supply
Features
- Constant current design
- Protections: Short circuit/Over voltage
- Fully isolated plastic case
- Small and compact size
- Cooling by free air convection
- Class II power unit, no FG
- No load power consumption <0.5W
- IP42 design
- Suitable for LED lighting and moving sign applications
- 100% full load burn-in test
- Low cost/ High reliability
- 2 years warranty
Description
APC-16E series is one 16W AC/DC constant current mode single output LED power supply. It accepts nput 180-264VAC and provides two models with ditferent output current, 350mA and 700mA, respectively, that the small wattage LED applications employ the most frequently. Exploiting Class l design (without FG pin) and adopting the 94V-0 flame retardant plastic enclosure, APC-16E ideally fits the entry-level LED applications.
Model Encoding
SPECIFICATION
| MODEL | APC-16E-350 | APC-16E-700 | |
|
OUTPUT |
RATED CURRENT | 350mA | 700mA |
| DC VOLTAGE RANGE | 12~48V | 9~24V | |
| RATED POWER | 16.8W | 16.8W | |
| RIPPLE & NOISE (max.)Note.2 | 300mVp-p | 250mVp-p | |
| VOLTAGE TOLERANCE Note.3 | ±5.0% | ||
| CURRENT ACCURACY | ±8.0% | ||
| LINE REGULATION | ±1.0% | ||
| LOAD REGULATION | ±3.0% | ||
| SETUP, RISE TIME | 500ms, 200ms / 230VAC at full load | ||
| HOLD UP TIME (Typ.) | 20ms/230VAC at full load | ||
|
INPUT |
VOLTAGE RANGE Note.4 | 180 ~ 264VAC 254 ~ 370VDC | |
| FREQUENCY RANGE | 47 ~ 63Hz | ||
| POWER FACTOR (Typ.) | PF>0.5/230VAC at full load | ||
| EFFICIENCY(Typ.) | 83% | 82% | |
| AC CURRENT | 0.3A/230VAC | ||
| INRUSH CURRENT(Typ.) | COLD START 45A(twidth=210μs measured at 50% Ipeak) at 230VAC | ||
| MAX. No. of PSUs on 16A CIRCUIT BREAKER | 13 units (circuit breaker of type B) / 23 units (circuit breaker of type C) at 230VAC | ||
| LEAKAGE CURRENT | 0.25mA / 240VAC | ||
| PROTECTION | OVER VOLTAGE | 50.4~ 60V | 27.6~ 33.5V |
| Protection type : Shut off o/p voltage, clamping by zener diode | |||
|
ENVIRONMENT |
WORKING TEMP. | -30 ~ 70℃(Refer to “Derating Curve”) | |
| WORKING HUMIDITY | 20 ~ 90% RH non-condensing | ||
| STORAGE TEMP., HUMIDITY | -40 ~ +80℃, 10 ~ 95% RH | ||
| TEMP. COEFFICIENT | ±0.2%/℃ (0 ~ 50℃) | ||
| VIBRATION | 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes | ||
|
SAFETY & EMC (Note 5) |
SAFETY STANDARDS | IP42,BS EN/EN 62368-1 approved | |
| WITHSTAND VOLTAGE | I/P-O/P:3.75KVAC | ||
| ISOLATION RESISTANCE | I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH | ||
| EMC EMISSION | Compliance to BS EN/EN55032,BS EN/EN61000-3-2,BS EN/EN61000-3-3 | ||
| EMC IMMUNITY | Compliance to BS EN/EN55035,BS EN/EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV) | ||
|
OTHERS |
MTBF | 6106.2K hrs min. Telcordia SR-332 (Bellcore) ; 1014.0K hrs min. MIL-HDBK-217F (25℃) | |
| DIMENSION | 77*40*29(L*W*H) | ||
| PACKING | 0.1Kg; 120pcs/14Kg/1.06CUFT | ||
| NOTE | 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristic for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft). 7. This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPF/XLG series are recommended.) 8. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf ※ Product Liability Disclaimer For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx |
||
Mechanical Specification
Block Diagram
Derating Curve
Static Characteristics
Applications
- Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices) (Note. 7)
GTIN CODE
MW Search: https://www.meanwell.com/serviceGTIN.aspx
Documents / Resources
 |
MW APC-16E series 16W Single Output Switching Power Supply [pdf] Instruction Manual APC-16E series, 16W Single Output Switching Power Supply, APC-16E series 16W Single Output Switching Power Supply, Output Switching Power Supply, Switching Power Supply, Power Supply |
