8BitDo Ultimate Bluetooth Controller with Charging Dock

Overview

• Press the home button to turn on the controller.
• Hold the home button for 3 seconds to turn off the controller.
• Hold the home button for 8 seconds to force the controller off.

Switch

• System requirement: Switch 3.0.0 or above.
• NFC scanning, IR camera, HD rumble, and notification LED are not supported.

Bluetooth Connection

1. Press the home button to turn on the controller.
2. Hold the pairing button for 3 seconds to enter its pairing mode, the status LED will start to blink rapidly.
   (This is required for the very first time only)
3. Go to your Switch settings–Controllers and Sensors–Change grip/order, then wait for the connection.
4. The status LED will remain solid when the connection is successful.

Wired Connection

• Please ensure the [Pro Controller Wired Communication] is enabled in the system setting.
• Connect the controller to the Switch via a USB cable and wait until the controller is recognized by the system to play.

Battery

• 16 hours of playtime with a 480 mAh built-in lithium battery pack, rechargeable with 2 hours of charging time.

Support

• Please visit support.8bitdo.com for further information & additional support.

Documents / Resources

8BitDo Ultimate Bluetooth Controller with Charging Dock [pdf] Instructions Ultimate Bluetooth Controller with Charging Dock, Bluetooth Controller with Charging Dock, Controller with Charging Dock, Charging Dock

References

• User Manual