3DMAKERPRO MOLE Scanner Standard Bundle Matter Hackers Instruction Manual
HARDWARE CONNECTION
Plug one side of the data transmission cable (as it’s showing Device Cable) into the scanner, another into the computer USB2.0 port and power adapter
Install the tripod as shown above.
Device Cable
Plug the device cable into the port of the scanner, make sure the red dot is lined up with the groove on the port
The small cable on the plug can assist you to pull it out.
Turntable Cable
The turntable can be powered up by connecting it to the computer or the power adapter with the turntable cable.
PACKING LIST
- Scanner Body
- Turntable Top’
- Turntable?
- Turntable Cable
- Tripod
- Device Cable
- Power Adapter
- Manual
* Product images are for illustrative purposes only.
*1234 Not included in the Standard Combo.
Operating System Requirement
Minimum: Intel Core i5 8th, 16GB RAM, MX250 GPU with 2GB VRAM
Recommended: Intel Core i7 8th, 16GB RAM, NVDIA1060 GPU with 4GB VRAM
To prevent antivirus software from blocking the driver, please uninstall the antivirus software.
Check the Tutorial below to know how Mole works. https://youtu.be/EpBBW7k2zMU
Download latest JMStudio from https://forum.jimumeta.com/home/help/download.html
Get latest Manual from https://forum.jimumeta.com/home/help/manual.html
3DMAKERPRO
@3DMakerProCares
@official3DMakerPro
@3DMakerPro
https://store.3dmakerpro.com/
service@3dmakerpro.com
JimuMeta
@JimuMeta
@JimuMeta
https://www.jimumeta.com/
service@jimumeta.com
Documents / Resources
 |
3DMAKERPRO MOLE Scanner Standard Bundle Matter Hackers [pdf] Instruction Manual MOLE Scanner Standard Bundle Matter Hackers, MOLE, Scanner Standard Bundle Matter Hackers, Standard Bundle Matter Hackers, Bundle Matter Hackers, Matter Hackers |