SmartWings Helix Remote Programming Guide Instruction Manual

SmartWings Helix Remote Programming Guide

Button Function Description

Technical Support

Wall Mounted Magnetic Suction Bracket

• Place the magnetic bracket horizontally on the wall, mark the wall through the two small holes in the middle, fix the magnetic bracket at the marked position with screws, and then attach the rubber pad.

Charging Instructions

Initial Setup Programming

Pairing Remote To Motor

Note: Repeat the above steps to remove this remote channel.

Change Motor Direction (If Needed)

1. First method: This method applies only during the initial setup. Before proceeding, check the motor direction by holding UP or DOWN. If the shade doesn’t operate as expected, adjust the motor direction.
2. Second method: If the limits have already been set, the first method will not work. Please follow the second method.

Set Upper Limit

Set Lower Limit

Save Favorite Position

Step 01

Step 02

• Once you have completed the above two steps, press and hold the STOP button for 2 seconds, and the shade will move to the preset favorite position.
• To cancel the favorite position, simply repeat the same two steps

Initial Setup Programming

Adjust Upper Limit

Adjust Lower Limit

Adjust Motor Speed

To Increase Speed

To Decrease Speed

Mirror Remote

Step 01

Step 02

Step 03

Percentage Mode and Tilt Mode

Switch Between “Percentage Mode” And “Tilt Mode”

Note:

• The factory default is percentage mode.
• Dimming cannot be performed when the shade has not reached the maximum downstroke point.

Enter Tilt Mode:

Enter Percentage Mode:

Motor Operating Instructions In “Percentage Mode”

• When the emitter is in Percentage Mode, the percentage of window opening/closing can be controlled by rotating the control ring.
• Close the shade by turning the Control Ring counterclockwise; when the lights are all off, the shade is fully closed
• Open the shade by turning the Control Ring clockwise; when the lights are all on, the shade is fully open.

The position of the shade corresponding to the “percentage indicator”

Motor Operating Instructions In “Tilt Mode”

• When the emitter enters Tilt Mode, the light transmission of the blinds / wood blinds / ShangriLa shades can be controlled by rotating the control ring.
• Gently turn the control ring so that as the indicator lights up gradually in a clockwise direction, the shade increases the amount of light that can pass through.
• When the indicator lights up gradually along the counterclockwise direction, the shade decreases the light that can pass through.

Additional Features

Matches the tilt mode used by older versions of the motor.

Note:

• The factory default is percentage mode.
• Dimming cannot be performed when the shade has not reached the maximum downstroke point.

Enter Tilt Mode (compatibility):

Enter Percentage Mode (compatibility):

Troubleshooting

• Shorter-than-expected emission distance / reduced sensitivity: If you find the emission distance obviously short or the device is less sensitive, change to another same new battery.
• Shade does not operate as expected: If the shade doesn’t operate correctly when you hold UP or DOWN during initial setup, adjust the motor direction. If limits have already been set, use the second method for changing motor direction.
• Dimming not working: Dimming cannot be performed when the shade has not reached the maximum downstroke point.
• Channel behavior confusion: Remember that one screen number corresponds to one control channel. If the screen number shows 0, all channels are effective (group control state).