SmallRig WR-06 Wireless Remote Controller Instruction Manual

SmallRig WR-06 Wireless Remote Controller
Instruction Manual

To ensure user safety and prevent damage from improper use, please read the “Important Notes” section of this manual carefully before use and keep the manual for future reference.

Preface
Thank you for purchasing the SmallRig products.

Important Notes
• Please read this Operating Instruction carefully.
• Do not use this product in water; it is not dustproof or waterproof.
• Avoid dropping the product, collisions, or strong impacts.

Product Introduction
Welcome to use the WR-06 wireless controller. This device can be used to control mobile phone photography and video recording.

Package Contents
Wireless Controller × 1
Operating Instruction × 1
Warranty Card × 1

Product Structure

Function Descriptions

• Using the wireless controller:

1. Power on/off
2. Connection
3. Shooting
4. Off-camera shooting
5. Charging
6. Compatibility instructions

1 Power on/off
Long-press the wireless controller button for 3 seconds to power on/off. When no operation is performed and the controller is not connected to a mobile phone, it will automatically power off after 5 minutesWhen connected to a mobile phone, it will automatically power off after 30 minutes.

2 Connection
After powering on the wireless controller, the green light will flash and enter the Bluetooth pairing mode. Search for “SmallRig WR-06” in the Bluetooth connection list of your mobile phone. When pairing is successful, the green light will turn off.

3 Shooting
Enter the mobile phone shooting interface. In photo mode, press the button to take a photo. In video mode, press the button once to start recording and press again to stop recording.

4 Off-camera shooting
Take the wireless controller out of the expansion frame to enable immediate shooting (effective range: within 15 meters without obstruction).

5 Charging
Charge via the Type-C charging port. The red light will stay on during charging and turn off when charging is complete.

6 Compatibility instructions
· Android: Compatible with API Level 21 (Android 5.0+).
· iOS: Compatible with iOS 11.0.

Using Strap
Using a lanyard: as shown in the figure..

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

To assure continued compliance, any changes or modifications not expressly approved by the party. Responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices).

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.

RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.