Elecrow ESP32 AI Camera Development Board Vision Sensor Board

Vaega o Masini

1. Ulutala Fofoga Fetalai
2. RGB Malamalama
3. Al Button
4. MIC
5. Ulutala UART
6. TF Card Card
7. Meapueata
8. Malamalama Fesoasoani
9. Toe Seti ki
10. Fofoga Fetalai
11. Ituaiga-C Taulaga
12. Malamalama Malosi
13. Ma'a Ma'a
14. BAT Header

Faʻavave Taiala

• Al Button:
  • In “Al Voice” mode, click to toggle the “Standby/Listening” status.
• Toe Seti Ki:
  • Single-click to reboot after firmware flashing failure or device malfunction.
• Malamalama Mana:
  • The red LED is on steadily when powered.
• Ma'a Ma'a:
  • When powered by the battery, the red light stays on while charging, and the green light stays on when fully charged.

Feso'ota'iga Feso'ota'iga

1. Plug in the Type-C cable to power on.
2. If you want to use the “Al Online” feature, you need to network pair and register the Al Agent first.
3. Open your phone/computer’s WiFi list, click on “Al_Camera_XXXX” to enter WiFi pairing mode.
   • Afai o le webpage does not open automatically, please visit 192.168.4.1 in your browser.
4. Choose an available 2.4GHz WiFi, enter the WiFi password, and click “Save Configuration”.
   • You can see your Wifi in “WiFi Network”.
   • Fa'aaliga: If you want to clear your network, open the “Settings” app, then open the “Configure Network”, and click “RECONFIGURE”.
5. Open the “Al Online” app, then open a browser and go to https://portal.thinknode.cc/ to access the Al Hub interface. If this is your first time logging in, you need to click the “Create Account” button to create an account.
6. After the account is successfully created and logged in, you will receive a 5000-point reward.
7. Click the “Al Hub” button to start “Add Agent”.
8. Click “Add Agent” and give your Al Agent a name.
9. Click “Manage devices (0)”, then click “Add Device”, enter the verification code, and confirm.
10. After completing “Add Device”, you can configure the character.
11. If you want to browse “Historical conversations”, you need to first enable “Local Short-term Memory” and save.
    • Fa'aaliga: If your 5000 points are used up, you need to click “Recharge” to purchase a plan that will allow you to regain points.

Fa'amatalaga Autu

• Igoa o oloa: Al Camera Module
• Pule Sili ESP32-S3R8
• Fa'aaliga 1.83-inch TFT-LCD Touch Screen
• Pixels 2 MP
• Uaealesi WiFi & Bluetooth 5.0
• moli 16MB
• TF Card Card Lagolago i le 128GB
• Fa'afeso'ota'i UART Interface. IC Pad
• Ulufale 5V/1A
• Fua 56.05*44.5*18.6mm
• Galulue Vevela -20°C i le 65°C

Pepa / Punaoa

Elecrow ESP32 AI Camera Development Board Vision Sensor Board [pdf] Taiala mo Tagata Fa'aoga ESP32 AI Camera Development Board Vision Sensor Board, ESP32, AI Camera Development Board Vision Sensor Board, AI Camera Development Board Vision Sensor Board, AI Camera Development Board, Camera Development Board, Vision Sensor Board, Sensor Board

Fa'asinomaga

• Tusi Taiala